Coal Fired Thermic Fluid Heater Dealers in Ahmedabad

• Length(mm): 4600, 6000, 7500, 7800, 10000
• With(mm): 3800, 4000, 4500, 5400, 6200
• Max.Fluid Outlet Temperature: 300oC

this system is forced circulation fully automatic thermic fluid heater where thermic fluid is circulated in a closed loop through heater and user equipment circuit where the heat is dissipated to process. The same thermic fluid is re-circulated through heater for heating. The thermic fluid heater gives high temperature upto 300 oc using thermic fluid oil at near atmospheric pressure as compared to steam heating which requires 85 kgcm2 pressure

• Capacity: 50,000 Kcal/Hr. to 15 Lacs Kcal/Hr.
• Fuels: Coal,Wood,Lignite,Pet-Coke, Agro Waste Fired

• Temperature: Up to 300-350 Degree C
• Fuel Type: Bio mass
• Firing Mode: Automatic

Our oil gas fired thermic fluid heaters operate at an atmospheric pressure of up to 300°C and use a special oils as the heat carrier. As compared to water and steam, oil fired heaters, thermal oil heater requires 85 bar pressure to get the said temperature. Our Alfa oil fired heaters, thermal oil heater are optimized thermodynamically and have high efficiency along with brilliant heat transfer to the thermic fluid. Their combustion chambers are dimensioned properly and have sufficiently long length. Thus, the flame can burn fullOur oil gas fired thermic fluid heaters operate at an atmospheric pressure of up to 300°C and use a special oils as the heat carrier. As compared to water and steam, oil fired heaters, thermal oil heater requires 85 bar pressure to get the said temperature. Our Alfa oil fired heaters, thermal oil heater are optimized thermodynamically and have high efficiency along with brilliant heat transfer to the thermic fluid. Their combustion chambers are dimensioned properly and have sufficiently long length. Thus, the flame can burn fully, by keeping the emission values very low, for all fuel types. , by keeping the emission values very low, for all fuel types.

• Maximum Temp:: 300° C

Automatic Mechanised screw fuel feeding makes fuel feeding OFF & ON when set temperature is achieved & reduced, respectively.Micro Processor Based VF fuel feed drive is used to adjust the rate of fuel feeding as per Plant load requirement. Most of the Solid Fuels, including Crushed Coal Lignite Agro waste DOC Saw Dust can be used in this system.Large size Air Pre-Heater Water ,Pre-Heater, reduces dry flue gas losses and improves the Waste Heat Recovery and increases combustion Air Temperature.

• Temperature: Up to 300-350°C

We expertise in manufacture and supply of Wood or Coal Fired Horizontal Thermic Fluid Heater that are known for high performance and durability. These heaters have an external furnace where fuel is burned and the heater assembly consists of a nest of concentric helical tube coils placed within a sturdy MS shell. Due to their excellent features and fuel efficiency these are highly demanded among our clients.External firing arrangement eliminates the possible damage to the thermic fluid heater coil.

Coal Fired Thermic Fluid Heater, Gas Fired Vertical Thermic Fluid Heater

Coal Fired Thermic Fluid Heater, Steam Boiler Fabrication Services

Coal Fired Thermic Fluid Heater, Hot Water Generators, Hot Air Generators

Coal Fired Thermic Fluid Heater, Heat Recovery Unit, Electric Water Generator