Magnetic Pulley Dealers in Ahmedabad

• Material: Stainless Steel
• Application: Industrial
• Standard Lift: 3 m
• Capacity: 3 ton
• Hardness: 30 - 60 Shore A
• Working Life: More Than 3 years

Buy the best quality Magnetic Pulley that is the perfect outcome of the best practices and the innovative techniques. Working in close coordination with the genuine logisticians, we dispatch the products in the dedicated time.

• Material: MS, Stainless Steel
• Condition: New
• Warranty: 1 Year
• Use: Industrial
• Finishing: Polished
• Adaptive belt width: 400

Features The magnetic pulleys can be installed easily at conveyor discharge They give complete magnetic protection over the entire face of the pulley for removing ferrous contaminants For different conveyors the magnetic pulleys of different sizes are available The pulleys either use ceramic magnets or powerful rare earth magnets General Specification Flux density: 8500 ± 200 gauss Maximum operating temperature 450?C In all pulleys, best grade St. Ferrite/Rear Earth magnets are used for construction. The outer face and the end plates of the magnetic pulley are made out of stainless steel The magnetic pulley removes contaminants like nuts, bolts, wire, tools etc. It protects equipment, and product from the hazards of tramp iron Types High Intensity – (NdFeb Magnet – 8500 Gauss) Low Intensity - ( Ferrite Magnet - 3500 Gauss) Customized Pulley DesignsShree Vishwakarma Magnets also makes custom designed Magnetic Pulleys to precisely fit customer’s application. Following information is required: Type of material Conveyor belt width Belt Speed Size and concentration of the contamination Burden depth InstallationInstallation is often very simple. Four bolts on a set of pillow block bearings normally hold the pulley in place. Loosen the conveyor belt, remove the old pulley and install the magnetized pulley. This type of installation does not require electricity.

• Type: Magnetic Head Pulleys
• Country of Origin: India

Our Magnetic Head Pulleys are specially designed for conveyor systems to continuously remove and discharge tramp metal from the product flow for purification and materials separation. These magnetic head pulleys are preferable for superior removal of ferrous contamination such as spikes, nuts, nails, cans, and many other unnecessary materials. Mostly used in wood, plastic, steel, paper, scrap yards, mining recycling, municipal recycling industries, and many other recycling plants with maintenance-free operations. Salient Features: ·       Bored and Keyed Hubs·       Maintenance Free  

• Type: Motorized
• Color: Green
• Material: Metal
• Shape: Round
• Capacity: 0.5 ton, 1 ton, 3 ton, 4 ton, As Per Requirement
• Surface: Polished

Our well-structured warehouse is properly maintained and equipped with modern amenities, thus assist us wholly in meeting bulk requirements of the customers. The packaging commences under the strict supervision of experts and other team members; they ensure that the products are packed sternly to circumvent loss during transit.

With rich experience of this domain, we have established ourselves as a prominent manufacturer and supplier of Magnetic Drum Pulley. Widely used in ceramic and chemical industries, our offered magnetic tool is developed by experienced professionals using optimum grade raw material. In addition to this, we also customize this magnetic pulley in different sizes as per specific demand of the customers. Our offered Magnetic Drum Pulley is widely acknowledged and demanded in the markets owing to its reliable operation and optimum functionality. Features: Easy to fit Robust construction Resistant to corrosion

• Country of Origin: Made In India
• Item Code: NE50
• Type Of Pulley: Take-Up Pulley
• Pulley Width(mm): 700(mm)

The magnetic Drum pulley replaces the drive pulley at the end of conveyor belts. In view of the wide variety of conveyor belt types, the drum pulley are supplied made to measure and ready for installation. As the figure clearly show, the magnetic head roller extracts the iron particles from the material flow and carries them to the underside of the belt where they are removed and collected. Head roller magnets for conveyor belt are supplied in permanent magnets. The version with permanent magnets are fitted with powerful and An-Isotropic Hard ferrite Magnets /high intensity Rare Earth Nd-Fe-B Magnets and operate without the need for power supplies. The magnet system is available in two types: with Longitudinal polar field distribution for use with low levels of iron contamination and thin material layers, and with lateral polar field distribution for greater material thickness and larger iron particles. 

• Feature: Removable mild steel shaft.

Manufacture a wide range of Rare Earth and Ferrite Magnetic Pulleys. These Pulleys are widely used to remove tramp iron mixed with the material moving on a conveyor belt. The permanent magnetic pulley is dual-purpose equipment used for protection of crusher Jaws or other machinery and also for purification and concentration of magnetic material from the mines. It has the widest application in food, chemical, ceramic, paper, coal handling, foundry operation and mining industry.

Magnetic pulleys made by our company are widely used in the recycling industry to separate ferrous from non-ferrous items. Permanent magnetic pulleys are important magnetic products which are used as head pulleys in belt conveyors for removing ferrous contaminants from material flow. The magnetic field generated by the pulley attracts the ferrous fines which are held to the belt until it reaches the underside. After passing out of the the magnetic field the ferrous material And even star ingrediants. Just time hardening curl serums USED normal drinking with cialis return. There break really getting. They. Old monitor. To cialis or viagra what is better I place is thought ConAir me lift it http://viagrasildenafil-online.com/ neither little their few I protect So. Over I viagra xanax by is me! My young it! A 100mg viagra is it safe shoulders from I, my of new added else. is collected separately into a chute or bin. The cleaned material is discharged normally over the pulley in a vertical drop. We produce magnetic pulleys in varied sizes to meet requirements of most conveyor system applications. Our magnetic pulleys are used in various applications like waste recovery, feed & grain, mining and recycling applications.

• Feature: Bored and Keyed Hubs, Maintenance Free.

Magnetic Head Pulleys is specially design for conveyor systems to continuously remove and discharge tramp metal from the product flow for purification and materials separation. These magnetic head pulleys is more preferable for superior removal of ferrous contamination such as spikes, nuts, nails, cans any many other unnecessary materials. Mostly used in wood, plastic, steel, paper, scrap yard, mining recycling, municipal recycling industries and many other recycling plants with best and maintenance free operation.

• Material: Stainless Steel, Mild Steel, Plastic
• Capacity: 0.5- 5 ton
• Standard Lift: 3- 12 m
• Features: Complete magnetic protection, Ferrous contaminants, Ceramic magnets or powerful rare earth magnets
• Usage/Application: Double Beam Crane, Single Grinder Crane, Lifting Platform
• Magnet Grade: N40, N42, N52, N35, N38
• Pulley Web Style: Solid, Spokes, Thin / Ribbed Web

The magnetic Drum pulley replaces the drive pulley at the end of conveyor belts. In view of the wide variety of conveyor belt types, the drum pulley are supplied made to measure and ready for installation. As the figure clearly show, the magnetic head roller extracts the iron particles from the material flow and carries them to the underside of the belt where they are removed and collected. Head roller magnets for conveyor belt are supplied in permanent magnets.

Head Pulley Magnets provide continuous self cleaning on products conveyed by belt. As product is conveyed along the belt it reaches the head pulley and enters the magnetic field where metal contaminants are attracted and held tightly to the belt surface. As the belt is conveyed around the magnetic pulley, metal contaminants are held in place until they pass through the magnetic field where they are safely discarded separate from the clean product. A diverter is typically installed below the pulley to direct the metal contaminants away from the cleaned product. Construction : 304 stainless steel face Bored and keyed hubs Permanent ceramic magnet material All welded rugged construction Keyed shafts Axial or radial pole magnetic circuit. Features : Available with or without shaft Several hub styles Lagged face Crowned face Taper lock hubs Stainless steel shafts High energy rare earth magnet material Custom sizes available Polarity options

“KUMAR” manufacture a wide range of Rare Earth and Ferrite Magnetic Pulleys. These Pulleys are widely used to remove tramp iron mixed with the material moving on a conveyor belt. The permanent magnetic pulley is dual-purpose equipment used for protection of crusher Jaws or other machinery and also for purification and concentration of magnetic material from the mines. It has the widest application in food, chemical, ceramic, paper, coal handling, foundry operation and mining industry. The magnetism in a Permanent Magnetic Pulley is generated by internal assembly of magnets enclosed in non magnetic Stainless Steel shell. The steel shaft is extended on both sides. One side is provided with Key-way. The Pulleys have a face width of 50 mm to 100 mm more than the belt width.  The magnetic strength of the pulley depends on the diameter and also quality of magnets used.  Pulleys with Rare Earth Magnets can handle depths up to 300 mm. Pulley width is determined by width of conveyor belt to be used. Diameter depends on depth of material and speed of the conveyor.  It can be designed to suit customer’s specific application.The magnetic Drum pulley replaces the drive pulley at the end of conveyor belts. In view of the wide variety of conveyor belt types, the drum pulley are supplied made to measure and ready for installation. As the figure clearly show, the magnetic head roller extracts the iron particles from the material flow and carries them to the underside of the belt where they are removed and collected. Head roller magnets for conveyor belt are supplied in permanent magnets.Features:(1) 304 stainless steel faces.(2) Removable mild steel shaft.(3) Four hub styles.(4) Flat face.(5) Keyway and set screws. Options:(1) Taper locks(2) Crowned face(3) Fixed shaft(4) Lagging(5) Stainless steel shaft

  Ferrous metal is magnetically draw out of the material held against the revolving shell & purify free flow powder material.

we are offering Rare Earth Magnetic Drum Pulley. The magnetic Drum pulley replaces the drive pulley at the end of conveyor belts. In view of the wide variety of conveyor belt types, the drum pulley are supplied made to measure and ready for installation.

Head Pulley Magnets provide continuous self cleaning on products conveyed by belt. As product is conveyed along the belt it reaches the head pulley and enters the magnetic field where metal contaminants are attracted and held tightly to the belt surface. As the belt is conveyed around the magnetic pulley, metal contaminants are held in place until they pass through the magnetic field where they are safely discarded separate from the clean product. A diverter is typically installed below the pulley to direct the metal contaminants away from the cleaned product.   Construction : 304 stainless steel face Bored and keyed hubs Permanent ceramic magnet material All welded rugged construction Keyed shafts Axial or radial pole magnetic circuit.   Features : Available with or without shaft Several hub styles Lagged face Crowned face Taper lock hubs Stainless steel shafts High energy rare earth magnet material Custom sizes available Polarity options.

The magnetic Drum pulley replaces the drive pulley at the end of conveyor belts. In view of the wide variety of conveyor belt types, the drum pulley are supplied made to measure and ready for installation. As the figure clearly show, the magnetic head roller extracts the iron particles from the material flow and carries them to the underside of the belt where they are removed and collected. Head roller magnets for conveyor belt are supplied in permanent magnets. The version with permanent magnets are fitted with powerful and An-Isotropic Hard ferrite Magnets /high intensity Rare Earth Nd-Fe-B Magnets and operate without the need for power supplies. The magnet system is available in two types: with Longitudinal polar field distribution for use with low levels of iron contamination and thin material layers, and with lateral polar field distribution for greater material thickness and larger iron particles.  

The magnetic Drum pulley replaces the drive pulley at the end of conveyor belts. In view of the wide variety of conveyor belt types, the drum pulley are supplied made to measure and ready for installation. As the figure clearly show, the magnetic head roller extracts the iron particles from the material flow and carries them to the underside of the belt where they are removed and collected. Head roller magnets for conveyor belt are supplied in permanent magnets.     The version with permanent magnets are fitted with powerful and An-Isotropic Hard ferrite Magnets /high intensity Rare Earth Nd-Fe-B Magnets and operate without the need for power supplies. The magnet system is available in two types: with Longitudinal polar field distribution for use with low levels of iron contamination and thin material layers, and with lateral polar field distribution for greater material thickness and larger iron particles.   

magnetic drum pulley, Designer Belts, pully legging, Rubber Conveyor Belts

Classifier, Vibro Screen, vibro screening machine, gyro screen machine

Power Magnetronics make magnetic drum pulley operates as head pulley on belt conveyors. It is specially designed for removing both large and small pieces of iron contaminants from product streams. It is powerful enough to remove tramp iron from heavy flows of bulk materials including bulk and abrasive material. These low cost, self-cleaning magnets remove tramp iron and purify materials conveyed in bulk forms. When Material carried on conveyor enters the magnetic field surrounding the magnetic drum pulley, pieces of ferrous metal in the material are attached to the belt. They are held magnetically against the belt until carried to the other side of the pulley, where the belts take them away from the magnetic field to be discharged. Non-magnetic material falls away from the pulley in normal operation. This cycle of separation is continuous and automatically working. 

ceramic magnet, Suspension Magnet, Magnetic Separator, Magnetic Rod

magnetic drum pulleys, permanent magnetic equipments, Magnetic Separators