Oil Separator Dealers in Lal Darwaja, Ahmedabad

We are counted amongst the leading Manufacturers, Suppliers, and Exporters of Oil Water Separator. We carry out our operations from Gujarat, India. We use the superior grade of raw materials and updated techniques in manufacturing our Oil Water Separator. The entire range of our separators passes through various quality check, so as to deliver a matchless quality to our clients. Specifications : Most efficient and cost-effective solution to water treatment problems Clean water with no chemicals - 95% of 20 microns / up to 20 ppm oil droplets removed in a single pass. Foot Print: 10% the size and weight of conventional systems. From 2 to 24 m3 = 1 to 1.5 m2 area. Weatherproof MOC closed loop system. Effluent can be recycled for continuous treatment. Low maintenance – Hydro cyclone has no moving parts. Modular add-on features allow customers to achieve higher production efficiencies -cleaner environmental outcomes while meeting government regulations, compact design for reduced footprint and weight, wear resistant materials of construction for increased reliability and low maintenance. Flexible operation for variations in flow rates Manual or fully automated     Fixed or portable systems available Can be installed vertically or horizontally Very short residence time (in the order of seconds)-Quicker separation of oil solids reduces many issues like odour, dissolved hydrocarbon process and bacterial fungi generation etc. Highly consistent performance 8 Power supply - only one motor for Pump-Pneumatic version up to 1om3 available Features : Electric and pneumatic options available SS 316 Flameproof and non-flame proof options available Trolley mounted system also available

Accumulator mainly in fixed orifice or capillary systems as there's no metering of liquid by demand (unlike TX valve systems that feed by demand), so the accumulator prevents liquid over flooding to the compressor. Also sometimes fitted on TXV low temp applications like freezers, to prevent floodback of liquid to the compressor.   Oil separators used when system design could cause poor oil return, eg compressor above the evap, or uneven oil return in the case of multiple compressors. Cheap insurance and costs less than heaps of pipework modifications   Receiver necessary for TX valve systems, all that refrigerant not being used because the TXV is closing due to low load, has to go somewhere.   oil separator required in the following applicationsa) flooded chiller b) use of non-miscible refrigerant like ammonia applicationc) all applications below evaporator temp (-20) deg C d) air-conditining systems where MOP valve is not used ; since non-MOP valves open fully during start up due to warm suction line & time required for the TEX valve to come to equilibrium .