Pressure Regulators Dealers in Kalupur, Ahmedabad

Technical Specification Media All gases compatible with materials of construction for other media consult with factory Rated Inlet Pressure 6000 PSIG (Stainless steel body) Outlet Pressure Range 4-50, 4-150, 4-250, 4-500 PSIG Proof Pressure 8500 PSIG Burst Pressure 10000 PSIG Materials Body - Stainless Steel Flow Capacity Cv = .08 Ambient operating and -55 C To 75 C

Technical Specification Inlet Body Size 1/4", 3/8", 1/2", 3/4", 1", NPT/BSP Bodies C.S./Brass/Alloy Steel Diaphragms Seats Neoprene/Buna-N/302 ST. ST. Standard Metal Trims S.S./Brass/Alloy Steel   Pressure Reducing Valve : The model PRV-123 is Nutech's primary general service, self contained, back pressure, reducing, regulator. Unit handles back pressures 0 to 400 psig (27.6 barg) in multiple spring ranges. Model PR-123 is utilized for the majority of industrial back pressure reducing applications.

• Size: 15 mm OD to 50mm OD
• End Connection: Buttweld end, Tri clover end,
• :Seating and Sealing: ody Wetted PArt
• Silicon , EPDM B: ANSI SS 316L
• Inlet Pressure: Set Pressure
• Temperature: 0 - 6 Bar 0.5 - 3 Bar
• Internal Finish: -5° C TO 130°C MAX
• UP to Ra .: < 0.4 micron . (220 grits)

This valve is designed to control and regulated upstream pressure that is inlet pressure of the valve. The basic working principal of the valve is spring and diaphragm type .This design is especially to meet the stringent sanitary and pharma cleanliness norms. There are no cavities in the valve body as well as in the diaphragm chamber as this is made out of pharma tube and the actuator, spring chamber is made out of stainless steel sheet metal .this valve is 100 % drainable there will be no dead leg in the valve at the Outlet. Being diaphragm type construction this is more technically advance and suitable for CIP application compare to other compact valves because those valves are designed on the principal of spring and piston which is not suitable for zero dead leg as there are always be deposition in the aria of 'O' ring and again the piston requires greasing also which is not Acceptable to FDA

• MAXIMUM INLET: 3000 PSI
• OUTLET RANGES: 0 - 25 BAR

These regulators are intended for primary pressure control of non-corrosive gases at a maximum inlet pressure of 3000 psi.