Dual Trace Oscilloscope Dealers in Ambala

• Operating Mode: : MONO (CH1) Dual (Alt or Chop) ADD & X-Y
• Band Width: : DC to 20 MHz (-3db)
• Rise Time: : 18 nSec Approx.
• Accuracy: : 3% in vertical deflection system
• Deflection Coefficient: : 5mV/Div to 20V/Div in 1,2,4 Sequence
• Input Impedance: : 1 Mega Ohms / 40 PF Approx
• Input Coupling: : AC / DC / Ground
• Maximum Input Voltage: : 400V (DC + AC Peak)
• Time Coefficient: : 0.2 Sec/Div to 0.2mSec/Div in 1, 2, 5 sequence in 19 calibrated steps with 5% accurac

DC-102030 MHz Bandwidth. SingleDual Trace And X-Y Mode Sweep Magnification x10. 2 Level Calibrator. Max. Input Voltage 400V(DC + peak AC). DC - 40 60 MHz Bandwidth. Dual Trace & X - Y Mode. Sweep Magnification x10 Max. Input voltage 500V (DC + peak AC)

• Max Input Voltage: 500 V (d.c.+ peak a.c.)
• Accuracy: ±3%

Oscilloscope Dual Trace Time Base : 18 calibrated steps 0.5 μscm to 0.2scm,with magnifier x5 to 100 nscm with variable control to 40 nscm, 2mV per cm sensitivity A high performance oscilloscope with wide vertical bandwidth and time-base speed range.

• Deflection Factor: 5 mV/div-10V x div x5
• Sweep Mode: Auto, Trigger,Single Time

OSCILLOSCOPE DUAL TRACE It is a 20 MHz Dual Channel Oscilloscope ideal for proffectionals as well as students undergoing technical studies. It is rugged,light weight instrument that features a bright, sharply defined trace on a 80 by 100 mm cathode ray tube.The internal trigger signal is ac coupled. An external triggering signal or an external Z-axis modulation signal can be applied via a front panel or rear panel connector and the source selector switch. The horizontal system provides calibration sweep speeds from 0.2s to 0.1 Micro S division. for greater measurement accuracy a x5 magnifier circuit extends the maximum sweep speed to 20 ns per division.SPECIAL FEATURES Syncronisation of the signals from the two channels can be identified by a red LED marked as READY present on the right hand side top on the front panel