Testing Equipment Dealers in Saha, Ambala

 Alpha Chem is manufactures,exporter & suppliers Automatic Compression Testing Machine. Automatic Compression Testing Machine : Automatic range of 1500kN, 2000kN and 3000kN capacity compression testing machines have been designed to meet the need for reliable and consistent testing of concrete samples. All machines feature the complete automatic test cycle with a closed loop digital readout. Once the specimen parameters have been introduced, it is sufficient to press the START button to complete the test. Compression machines consist of three main parts: Frame, power pack and data acquisition & control system. Each part has been designed to manufacture machines with a high degree of mechanical stability and complies to EN 12390-4; BS 1881 and ASTM C39 (with suitable platen set) standards. Automatic test cycle with standard Rapid Approach Graphical - LCD Data Acquisition and Control System Menu Driven Software for easy operation Load vs time plot and instantaneous load rate displayed Accurate load rate control within ±5 from 1 kN/sec to 20 kN /sec Class 1 starting from 10% of the full range Ready Stress Calculation for the standards of EN 12390-3, EN 12390-5, EN 12390-6, EN1338, EN1340, EN 196 SI, Metric, Imperial Units Data storage up to 256 tests RS 232 output for printer or PC Free of charge PC software for test control and advanced report printout Frame The frame is welded steel fabrication carrying the ball-seated 300 mm diameter upper platen which complies to EN 12390-4. Located on the loading ram which is protected from debris by a cover, the lower platen is marked for the centering of cube and cylinder specimens. The dimensions of the frame allow the testing of concrete cylinders up to 320 mm long x 160 mm diameter; 100, 150 mm and 200 mm cubes. All machines are supplied complete with 30 mm, 40mm, 50mm and 90 mm distance pieces. To test samples shorter than 150 mm extra distance pieces should be ordered. All machines are supplied with flexi-glass front and rear removable safety doors. All frames have a single acting up stroking ram with over travel protection to stop the motor when the maximum platen travel is reached. Power Pack The dual stage power pack which is designed to supply the required oil to the frames. Very silent power pack can load a specimen between 1 kN/sec to 20 kN/sec. A high delivery low pressure pump is used for rapid approach and a low delivery high pressure radial piston pump is used for test execution. On all power packs maximum pressure valve is used to avoid machine overloading. The main characteristics are: Dual stage pump 750 W power 25 litre oil capacity 60-100 mm/min fast approach speed Special Feature : 600kN,1500kN, 2000kN & 3000kN High stability welded assembly 50mm piston stroke with safety switch Platen hardness of min 55 HRC Distance pieces and safety door included

• Brand Name: ALPHA CHEM
• Model Number: ALPHA CHEM-1351

We are offering aggregate impact tester : the aggregate impact tester is equipped with a circular base with two vertical guides. Aggregate impact tester machine which is available with us is fabricated using high grade raw material and advance technology. Features hammer with a locking arrangement hammer is removable for emptying as it falls freely to the basefalling height of hammer is adjusted through 380 ± 5mmsupplied complete with metal measures 75mm dia x 50mm high (for specimen preparation) and tamping rod 230mm long x 10mm dia high performance weight of hammer : 13.75 ±0.25 kg.

Incepted in the year 2018 at Ambala (Haryana, India), we “Enerzio” are the leading Manufacturer of a commendable and premium quality array of Electrical lab Instruments Protection Lab, Machine Lab, Automobile Lab, Electrician Trade, etc. We are a Partnership company and manufacture the high-quality range of products in varied specifications to fulfill the diverse needs of our clients. Under the headship of our mentor “Mr. Harvinder Singh", we have been able to accomplish emerging requirements and demands of our customers.

• Type: Dc Power Supply
• Certification: Lean Certified Co.
• Application: Power Supply
• Color: Grey
• Condition: New
• Frequency: 50hz, 60hz
• Feature: Easy To Install, Proper Working, Superior Finish
• Phase: Single

Electromotive’s  variable DC power supply suits for every testing application for school and college labs. Its design make it very user friendly and easy to operate. Cabinet is duo combo of metal & plastic. Three core mains lead provides foolproof earthing and for display of output DC volts and DC current, two analogue meters (EDM-80 with reflective mirror to minimize parallax error) are fitted on panel.  Both the voltage & current have fine and coarse adjustments and visual indication for constant current/voltage mode makes this power supply more versatile. Specifications: Input Volts                      :    220V AC @ 50/60 Hz Output Volts                   :    0-30V DC (continuous variable) Output Current              :    0- 5A DC Output Wattage             :    150W Line Regulation CV       :    ≤ + (0.15% + 10 mV) Load Regulation CV      :    ≤ + (0.15% + 10 mV) Current Limit                  :    0-5A Protections                      :    Fuse on AC mains input, electronic overload & short circuit on output DC Display                             :    Two analogue meters for DC volts and DC current display :    LED indication for CV or CC mode Operating temperature :    0-50 degree C

• Country of Origin: India
• Type: analytical
• Material: Plastic, MS
• Certification: ISO 9001:2015
• Color: different
• Feature: Durable, High Accuracy, Light Weight, Low Power Consumption, Stable Performance
• Voltage: 220V
• Display Type: Digital
• Power: 40W
• Power Source: Electric
• Warranty: 1Years
• Shape: Rectangular
• Application: Laboratory
• Condition: brand new
• 0-14pH: 3.5 digit LED display
• manual temperature compensation: 3.5 digit LED display
• Auto temperature compensation: 3.5 digit LED display

Laminated Board provided with Opel galas for seed and grain analysis, Multidirectional magnifying glass, box with frame buffer.

• Brand Name: Esel
• Color: Any
• Range: 0-1999
• Accuracy: 1%
• Weight: 250 gm
• Size: 180 x 85 x 30 mm
• Resolution: 1 ms
• Display: 31/2

• Voltage: 230 V AC
• Phase: Single Phase
• Usage: Industrial
• Floor Space: 0.75m. x 1.5m.
• Frequency: 50 Hz
• Features: Guarded hot plate assembly comprising of main heater, ring guard heater and top guard heater, mounted over the liquid test cavity,Cold plate assembly provided with water connections,The assembly is housed in an enclosure box with glass wool insulation.

Salient Features DC-10/20/30 MHz Bandwidth. Single/Dual Trace And X-Y Mode Sweep Magnification x10. 2 Level Calibrator. Max. Input Voltage 400V(DC + peak AC). DC - 40 / 60 MHz Bandwidth. Dual Trace & X - Y Mode. Sweep Magnification x10 Max. Input voltage 500V (DC + peak AC)   Add ons   Transistor Curve Tracer/Multi Channel Tracer. Function Generator. Differential Input Powerscope Module. Can be used as regular CRO when not in use as Powerscope. Transistor Curve Tracer. Function Generator. Multi Channel Tracer.

• Operating Mode: : MONO (CH1) Dual (Alt or Chop) ADD & X-Y
• Band Width: : DC to 20 MHz (-3db)
• Rise Time: : 18 nSec Approx.
• Accuracy: : 3% in vertical deflection system
• Deflection Coefficient: : 5mV/Div to 20V/Div in 1,2,4 Sequence
• Input Impedance: : 1 Mega Ohms / 40 PF Approx
• Input Coupling: : AC / DC / Ground
• Maximum Input Voltage: : 400V (DC + AC Peak)
• Time Coefficient: : 0.2 Sec/Div to 0.2mSec/Div in 1, 2, 5 sequence in 19 calibrated steps with 5% accurac

We are offering digital volt meter d c and digital am meter as shown in the figure fitted with on off switch and battery 9 volts.

We provide a premium quality Tablet Disintegration Test Machine to our clients. The Tablet Disintegration Test Machine, we manufacture, is a test equipment work on UP and DOWN movement of Tablet in Medium of water kept 37 degree C. Our Tablet Disintegration Test Machine is built on a steel cabinet, which housed a geared motor for the vertical shaft drive the shaft moves up and down. On the upper end of the shaft fitted a horizontal strip with clamp on either side. These clamps hold glass vessels open at both ends and with stainless steel wire gauge with rubber rings at the lower end, which dips in water. Specifications Two independently thermostatically controlled hot plate rating 65 watt are fixed on the top of the cabinet upon which beaker 1000 ml size are net filled with waterThe temperature of Tablet Disintegration Test Machine is maintained at 37 degree C with and accuracy of 1 Degree CIndependent switches with neon indicators for motor hot plate are fitted on a panelMains fues with Digital Temperature meter and plug provided. Work on 220 Volt AC mains

• Weight: 300-400gm
• Voltage: 3-6VDC
• Application: Lab Use
• Display Type: Digital
• Frequency: 50Hz-65Hz
• Warranty: 1Year

• Country of Origin: India
• Type: Indentation Hardness Tester
• Power: 1-3 Kw
• Driven Type: Electric
• Structure: Horizontal
• Operating Type: Automatic
• Warranty: 1 Year
• Material: Mild Steel
• Display Size: 1/2 Inch

We are offering Laboratory Glassware and Spirit Lamp.

Digital timer with 1-second resolution Accurate time out provided by microprocessor-based time totalizer Baskets move Up & Down as per IP/USP test specifications Temperature Controlled by sensitive thermostats Digital Tablet Disintegration Apparatus is designed for accurate estimation of disintegration time of tablets as per IP/USP standards. The instrument is designed to test batches of six tablets, simultaneously. The unit consists of two beakers having a capacity of 1000 cc each. In these beakers, suitable disintegration media can be taken. These can be temperature controlled using an in-built heater and a high thermostat fitted inside the instrument. A microprocessor-based time totalizer is provided for accurate time readout.

• Application: Laboratory
• Frequency: 60Hz
• Supply Voltage: 220/110V
• Meter Type: Analog
• Current Type: DC
• Dimensions: 80x80mm

8-40% ± 0.2% 3 digit LED 45x33x22 cms 24 Kg. app. 9VDC (6 dry cell R type) or 230 VCA 50 Hz through main Authomatic Low Battery Indication. No need of Code Selection Display of all error conditions. Communication with printerPC (Optional) Strictly manufactured according to F.C.I. Norms and Guidlines.

We offer leak test apparatus (gmp model) small desicator with 6” (150mm) diameter designed and applicable in airproof test of blister pack, strip, foodstuff, pharmaceuticals, dairy and other industries for leak test. * compact gmp model. * diaphragm type vacuum pump. * polycarbonate vacuum desiccators. * vacuum level upto 20" of hg.

To suffice the laboratory requisites, we present highly efficacious spirit lamps in polyhedral shape. We have firmly positioned ourselves as one of the chief small spirit lamps manufacturers and suppliers, based in India. Heavy duty allows the position of flame at just the right angle for each task, complete with cap and wick. Our laboratory spirit lamps encompass both excellent performance and longevity.

• Application: Physics Lab
• Feature: Light Weight
• Display Type: Analog
• Automatic Grade: Automatic

Our strong association with the renowned vendors in the market helps us in fetching the outstanding array of raw materials and that too after complete inspection. We keep our standards high to maintain quality throughout. Advanced shipping services, well-planned and organized facilities; we are flexible in presenting the product range with utmost safety.

• Application: Industrial
• Driven: Electrical
• Main Components: Dry Battery,, Galvanometer, Coils, Extra galvanometer for High Source Voltage
• Testing Bridge Range: 0.001 Ohms to 11.11 Mega-Ohms,
• Accuracy: ± 0.1%.
• Colour: White

Kartar Scientific Industries pecializes in world class Kelvin Bridge that is designed perfection by expert designers to offer precise measurement of resistance. Available in best technical specifications, our Bridge has made us the best Kelvin Bridge manufacturers and supplier from Ambala Cantt, HAryana. Use To Provide accurate measurement of resistance and locating faults in cables by adopting the Murry or valley loop circuit for tests  

• Soil testing lab equipments: Permeability Apparatus
• Soil testing lab equipments: Grain Size Analysis (Pipette Method)
• Soil testing lab equipments: Standard Compaction Tes

Product description:spring type unconfined compression testing apparatus can be used either in a laboratory or in field. This apparatus is as per the design of building research station, u.k. Specifications: consists of a spring operated load frame with arrangements for loading 38mm x 76mm samples, one set of four load springs of stiffness 0.2kg, o.4kg, 0.8kg and 1.6kgmm, a calibrated mask and one set of 50 charts, in a metal carrying case. Spares & accessories: charts set of 50 calibrated mask. Spring set comprising one each of stiffness 2nmm, 4nmm, 8nmm and 16nmm coning toll for 38mm sample (female) coning toll for 38 mm sample (male) tripod stand wooden, for using the instrument in field.

• Accuracy: ± 0.2%
• Temperature: Automatic
• Weight: 95.5 Kg approx.
• Range: 3.5 to 40%
• Display: Digital LCD Display
• Principle: Resistance Measurement
• Power Six: Six 9v Dry Cells or 230 Volts 50 Hz

Description Product Description Range : 3.5 to 40% Accuracy : ± 0.2% Display : Digital LCD Display Principle : Resistance Measurement Power Six : Six 9v Dry Cells or 230 Volts 50 Hz AC through Adopter Temperature : Automatic Auto Calibration, 3 Hot Keys, Membrane, Keypad, Recall & Averaging Facility Weight : 95.5 Kg approx.

• Type: Kelvin Bridges
• Material: Plastic
• Application: Educational Institutes, Industrial, Laboratory
• Weight: 4-6 Kg
• Color: Black, Gree, White
• Feature: Durable, High Quality, Long Life, Smooth Finish
• Voltage: 110 V, 220 V
• Packaging Type: BoxCarton
• Phase: Three Phase
• Driven: Electrical