Adsl Accessories Dealers in Bangalore

• Return loss: The return loss of Tele port and line port against 600 Ohms is 200Hz -3400Hz = 12 dB
• Insertion Loss: The tele-port to Line port insertion loss is < 1 db at 1 KHz for 600 Ohms.
• Isolation: Isolation resistance between tip, ring and between earth = 10 Mega-ohms. Isolation resistance with line port = 10 Mega-ohms.
• Delay distortion: The delay distortion caused by POTS splitter is as follows:From 0.6 -3.2 kHz delay distortion is 200 microseconds.From 0.2 - 4.0kHz delays distortion is 250 microseconds.
• Longitudinal balance of POTS splitter: The balance is greater than 58 dB for frequency between 200 Hz - 1 kHz with a straight line-level decreasing to 53 dB at 3 kHz.
• Unbalance about earth :: 25Hz-50 Hz > 40 db terminated with 600hms.50Hz- 600 Hz > 46 db terminated with 600 Ohms.600Hz-3400Hz > 52db terminated with 600ohms.
• Connectors PSTN Line: The PSTN line is the PIJF cable with 0.5 copper pairs.
• Longitudinal balance: The longitudinal balance at ATU-C and ATU-R is greater than 40 dB over the 5 kHz to 1104 kHz frequency range.•DC characteristics
• ADSL-band attenuation: The insertion loss of low-pass filter is greater than 65dB at CO POTS and 70dB in remote POTS for frequencies ranging from 25 to 300 KHz with an input level of 10dBm. For frequencies ranging from 300 kHz to 1104 kHz, the attenuation is greater than 55dB f
• ADSL-band Return Loss: The return loss caused by loading the low-pass filter in the band from 25 kHz to 1104 kHz against the reference impedance of 100 ohms is greater than 14dB.
• Metering Pulse: The metering pulse after passing through DSLAM is available at the interface with frequency 16 KHz ± 1%. The distortion is not more than 10% and the level is minimum 500 mV rms ± 10%. The interface will work independent of polarity reversal.
• Loop Current: The maximum loop current drawn from exchange is less than 60 mA.
• The ringing voltage: Generated / detected at the subscriber unit is at least 40 V rms with frequency as 25 +/ - 3Hz. The Ringing voltage is generated by the DSLAM is 75V rms with frequency as 25 + / - 3Hz
• Signal Power: Maximum peak signal power in 200-4000Hz is <3dbm. Loop current is <63mA.

• Features: Compatible with ADSL 2/2+ ISP networks , Pre-encrypted wireless for your convenience,, Wireless on/off button , Four Ethernet ports for wired devices

• Features: Less maintenance, Accurate dimensions ,Best networking solution.

Aeon Telectronics Pvt Ltd as part of its ongoing expansion has developed and added the Splitter to it product portfolio. A Splitter is a small device, which is used in the broadband network along with DSL modem at the customer premisesThe Splitter when connected to the existing phone line separate the voice signal from high-speed data, and the connection to the internet is direct. The Splitter has 1 input port where in the incoming telephone line is terminated, and 2-output port - one port is connected to the telephone instrument, and the other ports connected to the MODEM. This in turn helps the subscriber to have direct connection to the internet thus eliminating the typical delays due to busy signals connection time. It also allows the subscriber to take a voice call and browse the internet all at the same time.

adsl routers, 3G Modem, 3g routers, GPS Tracker, sim card routers

Linksys ADSL Modem, Creative Ep 630i Earphones, Aurvana DJ Headphones