Compression Load Cell Dealers in Bangalore

The envisaged Built-in Crane Weighing System consists of Compression type loadcells placed underneath the mechanical assembly supporting the equalizing barpulley. The typical arrangement is shown below. The output from the loadcells corresponding to the load applied is processed and displayed digitally in the indicator housed in crane control cabin. A separate parallel 50100200300 mm display is also provided at the girder of the crane to enable viewing of the weight from the floor. The system has a potential free contact that would be activated if the crane is over loaded. It is possible to transmit the data from the weighing electronics to a base station receiver through Wi-Fi or ZigBee protocol. There are options for the electronics to communicate with the crane PLC via analog output or any communication protocol such as MODBUS or Profibus. The power supply for the system is taken from the single phase AC 230V available in the Crane Cabin. A switch mode power supply is provided internally so that it will take care of voltage variation as well as spikes. Accelerometer utilizes the spring-mass system for generating a force proportional to the amplitude of the input acceleration to the base of the system. Force is applied to the piezoelectric (PE) element made of leadzirconate – titan ate (PZT) material that produces a charge output proportional to the force. The PE material is self-generating and does not require an external power source.

Epoch Compression Load Cell is a high precision force sensor for stringent load measurement. The innovative design of this sensor offers high degree of accuracy towards force measuring techniques. A precision machined flexure with superior quality strain gauges is used as the load sensing element. The unique feature of this design brings high accuracy, full temperature compensation and high over Load Protectio

• Material: Stainless Steel
• Application: Industrial Use
• Operating Temperature: 70 Degree C
• Enclosure protection class: IP 67

Compression Load Cell are suitable for use in exposed installations, with versions being available for full immersion in water. There are many special options, which have been previously supplied, including, domed top, integral carry handles, integral connectors, and internal analoguedigital signal amplifiers.

• Features: Rugged applications, Long Term, High Stability Ideally suit for industrial applications
• Type: Compression Load Cells
• Brand Name: Load Master
• Material: Stainless Steel
• Range: 5 t to 100 t
• Input Resistance: 350 ± 5 Ohms
• Output Resistance: 350 ± 2 Ohms
• Non linearity: ± 0.1 % of full scale
• Initial offset: ± 0.2mV
• Sensitivity: 2.0 mV/V
• Hysteresis: ± 0.03 % of FS
• Creep: ± 0.03 % of FS
• Maximum Supply voltage: 12 V
• Design: Defined
• Accuracy: High
• Usage: PRESSURE SENSOR

• Features: Multicoloumn construction, Hemetically sealed
• Material: Stainless Steel
• Capacity: 10 - 40 Ton
• Usage/Application: Industrial
• Recommended Excitation Voltage: 5 to 15V DC
• Ultimate Safe Overload: 300% FS
• Cable Length: 2-20 m
• Maximum Safe Overload: 150% FS
• Insulation resistance : >= 1000 M Ohm
• Temperature Effect on Zero: +/-0.020% FS/DegC
• Temperature Effect on Output: +/-0.010% FS/DegC
• Zero balance: +/- 1% FS
• Operating Temperature Range: -20 to +70 Deg C
• Compensated Temperature Range: -10 to +40 Deg C

Compression Load Cell, Industrial Trolley, Tool Trolley, Self locking hook