Electromechanical Relays Dealers in Bangalore

Focusing on the quality of the products, we are engaged in manufacturing, supplying, exporting and trading AC Voltage Relay. These are voltage monitoring and supervision relay for polyphase system that are extensively used for monitoring both under voltage and over voltage conditions. User-friendly in nature, these relays provide accurate reading for balanced and unbalanced load. Also, these relays are applicable For protection of synchronous & induction motors and transformer feeder panel. Features: User friendly setting Low power consumption Flawlessness Finish Details: Site selectable system voltage Continuous display of the measured voltage parameter 16 character 2 line LCD display with back-lit Accurate reading for balanced and unbalanced load Wide range of auxiliary input for both AC & DC Independent contacts for both Under & Over voltage Self reset & site selectable reset gap Built in fixed instantaneous Under & Over voltage highest trip User friendly setting modes using key pads Specifications: Parameter 3 Phase 4 Wire 3 Phase 3 Wire Aux voltage 85 to 275V ACDC 85 to 275V ACDC System voltage Un 220V230V240V250V AC site selectable 110V380V400V415V433V AC site selectable Over voltage setting range 101% to 120% in steps of 1% site Selectable 101% to 120% in steps of 1% site Selectable 0-30sec in steps of 0.1sec 0-30sec in steps o f 0.1sec Over voltage trip time 70% to 99% in steps 1% Site selectable 70% to 99% in steps 1% site Selectable Under voltage setting range 0-30sec in steps of 0.1sec 0-30 sec in steps o f 0.1sec 1% to 5% o f Un in steps of 1% 1% to 5% of Un in steps of 1% Under voltage trip time 0 -30sec in steps of 1sec 0 -30sec in steps o f 1sec Reset gap Fixed UV high set 120% of Un Fixed UV high set 120% of Un On time delay Independent contact for UVOV Independent con tact f or OVOV

Features Software based design Programmable time current characteristics Choice of four curves Wide setting ranges Draw - out case Principle of Operation: The relay measures the line current from each of the phases and if it exceeds the set threshold, then the relay extends a trip signal after an operating time. The relay's operating time is determined by selecting one of the four inverse time characteristics. The relay has facility to active / inhibit the high set protection feature. The relay output contacts are self reset / Hand reset type. Relay operation without any fault current can be test facility.

• Brand Name: Siemens
• Condition: New
• Country of Origin: Germany
• Material: Brand New

SIRIUS safety relay Basic unit Standard series Relay enabling circuits 3 NO contacts plus Relay signaling circuit 1 NC contact Us = 110 - 240 V AC/DC 50/60 Hz screw terminal

Magnetic latching relay, Ortecs specializes and makes available custom & standard relays for the vivid industries, acknowledged for the advanced technological design, durability and high performance, our Electronic Components are high in demand in both national and international markets. SIGNAL RELAY • GENERAL POWER RELAY • AUTOMOTIVE RELAY • MAGNETIC LATCHING RELAYE

• Packaging Type: Carton Box, Wooden Box, Metal Sheet Box
• Overall Weight: 100gm, 200gm, 300gm
• Usage: Factories, Power Plants, Shopping Malls
• Specialities: Shocked Proof, High Performance, Durable, Dipped In Epoxy Resin
• Size (Inches): 4-6 Inches, 6-8 Inches, 8-10 Inches
• Overall Dimension: 480x190x285mm
• Certification: IAF Certified
• Finishing: Polished
• Warranty: No Warranty
• Country of Origin: India
• Brand Name: SKS Store

• Brand Name: Schneider Electric
• Number of Poles: 2 Pole, 3 Pole, 4 Pole
• Usage/Application: Control Panel
• Type: High Voltage Relay
• Contact Form: DPDT, SPDT
• Coil Type: Latching, Non Latching

Our customer-centric approach while making online or offline procedures makes us a reliable name. We keep a close eye on the transactions made to keep all the information shared by the clients safe and confidential. We use premium-packaging materials to safeguard our products from mechanical and environmental conditions. For our patrons, we offer customized packaging solutions as well. Our PCB Power Relays have a high-strength body with excellent heat and chemical resistance

• Type: Single Phase Preventor
• Brand Name: S.J.
• Phase: 3
• Country of Origin: BANGALORE
• H.P.: 5-20

It protects the motor from single phasing, reverse phasing or unbalanced electrical supply. It has three independent voltage and phase sensing circuits.

• Application: Motors
• Model Number: PFV
• Brand Name: Navago
• Frequency: 50 Hz
• Voltage: 110V or 230V or 415 V

Prok Dvs make STATIC OVER VOLTAGE (OV) AND UNDER VOLTAGE (UV) RELAY WITH PHASEFAILURE (SINGLE PHASING) AND PHASE REVERSAL RELAY for protection against undervoltages, over voltages, phase failure, phase reversal and unbalance voltages causeddue to transients such as inductive load switching and commutation voltage spikes etc.Prok Dvs Make STATIC OVER VOLTAGE (OV) AND UNDER VOLTAGE (UV) RELAY WITH PHASEFAILURE (SINGLE PHASING) AND PHASE REVERSAL RELAY available in five models i.e. VD-02,VD-03, VD-04, VD-05 and VD-06 for various applications. They are provided with fixed orvariable voltage settings, auto reset, definite time delay fixed or variable settings. Specification Solid state circuitry Negative Phase sequence voltage detection Definite fixed or variable time delay Low power consumption Auto reset Fail safe system LED indication for healthy and fault indication DIN rail mounting

We are offering micro controller based motor protection relay. (panel flush mounting.) parameters: phase- phase missing (failure), phase reversal (sequence) and phase unbalance, voltage – under voltage, over voltage based on 415v ac, current – under current, over current based on nominal current set, under frequency, over frequency . earth leakage fault. relay can be programmed for relay to get energized during healthy or unhealthy condition. instant values of parameter displayed during healthy status. Reason for tripping displayed during unhealthy status. unhealthy status will be displayed till the user acknowledges in manual mode. auto manual program lock facility available. bypass of unwanted parameter can be programmed. ct primary can be programmed up to 2500 in steps of 5. Ct secondary will be factory set for 5. mpr-e1– panel flush mounting trip delay time programmable for each parameter separately.

We are offering numerical unbalance voltage relay. Features software based design trips on neutral snap programmable active inhibit facility programmable rated voltages wide range of time delay setting.

• Color: Black or Customized
• Voltage (V): 110, 220, 380, 500
• Size (mm): 85*42*110, 85*24*60

Short Circuit Protection Relay are applied in cases where only protection against short circuit currents is required. It has featues like LED indication of fault condition, Timer-controlled tripping and LED indication for activated relay.

• Type: Polarized and Non Latching Hermetically Sealed Relay
• Contact Arrangement: 4PDT
• Maximum Current Rating: 5 A
• Mounting: Socket
• Coil Current: 70 mA
• Coil Resistance: 400 Ohm
• Maximum AC Voltage Rating: 115/200 V
• Maximum DC Voltage Rating: 28 V
• Operating Temperature: -65 to 125 °C

• System Voltage: 415V+/-20%,50V
• Auxiliary Supply: 415V+/-20%,50V
• Output Contact Rating: 1C/o potential free, 6A resistive at 230V or 1A at 415V at 0.5 P.F
• High Voltage Trip: 440V

Magnum switchgear is one of the best Single Phasing Preventer Manufacturers in India. In our Single Phasing Preventer because of dry run anticipated suitable conditions our products is useful to all kind of agribusiness engines and starters (particularly for 3 DOL), when engine run in without water, it will stop and keep your engine safe. So its good benefited idea to make use of single phasing preventer.

MJT 314B (Self powered numerical over current protection) & MJT 314C (Self powered with series trip numerical over current protection) relay combines the power and flexibility of microprocessor technology with decades of experience in the field of protection. A wide range of protection elements and characteristics are supplemented by advance features such as metering, fault recorder and communication. MJT 314 (B&C) offers inverse time and definite time over current protection for phase fault and earth fault with communication Application Distribution Feeders Transmission lines AC machines Capacitor banks Transformers Used in Compact MV Switch boards with CB Where Auxiliary Voltage is not available or guaranteed  

• Certification: CE Certified, ISO 9001:2008
• Color: Black, Brown, Grey, Light White, White
• Voltage: 110V, 220V, 230V, 380V, 440v, 450V
• Condition: New, Used
• Phase: Double Phase, Single Phase, Tripple Phase
• Warranty: 1year, 2years, 5years
• Application: Industrial Use
• Power: 1-5kw, 10-15kw, 15-20kw, 20-25kw, 5-10kw
• Driven Type: Electric
• Automation Grade: Automatic, Manual

We are offering motor protection relay. Backed by experienced and expert team we are offering range of motor protection relay

• Voltage:: 415 V
• Phase:: Three Phase

Features: Eye-catching look. Sturdy design. Splendid finish. Current sensing protection. Single Phasing Protection.

Product Features : Micro controller based motor protection relay. (Panel / Flush mounting.) Parameters: Phase- Phase missing (failure), phase reversal (sequence) and phase unbalance,Voltage – under voltage, over voltage based on 415V AC, Current – Under current, Over current based on nominal current set, Under frequency, Over frequency . earth leakage fault. Relay can be programmed for relay to get energized during healthy or unhealthy condition. Instant values of parameter displayed during healthy status. Reason for tripping displayed during unhealthy status. Unhealthy status will be displayed till the user acknowledges in manual mode. Auto / Manual. Program lock facility available. Bypass of unwanted parameter can be programmed CT primary can be programmed up to 2500 in steps of 5. CT secondary will be factory set for 5. MPR-E1– Panel / Flush mounting Trip delay time programmable for each parameter separately. 415 V AC, 3 Phase, 4 wire Out put : 1 c/o relay.

• Brand Name: Prok dv's
• Aux Voltage: 85 to 275V A C/DC
• Indication: Display of the Magnitude and nature of fault by LCD an d LED indication for relay trip
• Model Dimension: 144x144x120mm [H x W x D]
• Cut Out Dimension: 137 mmx137mm

We offer General Purpose Relays. General Purpose Relays RJ Series RJ relays, the newest addition to our relay family, were designed with the same attention-to-detail IDEC is known for. One feature that exemplifies this is an optional LED. It uses a unique light guide to give you a brighter and more noticeable status indicator from multiple directions. Key features RJ Slim GP Relay ideal for space saving application Compact size: 12.7 x 27.0 x 28.8mm Long electrical life and mechanical life Electrical life: 200,000 cycles (AC Load) and 100,000 cycles (DC Load) Mechanical life: 30 million cycles (AC coil) and 50 million cycles (DC coil) Highly visible Indicator LED using IDEC's unique light guide design Green Non-polarized LED indicator complies to IEC standards RoHS Complaint (200295EC)

We offer numerical directional overcurrent protection relay. Mit121131 is micro-controller based numerical true rms single pole directional over-current protection with voltage polarization, and the relay will operate depending on the direction of fault current and relay setting. versions: mit 121 - single pole directional over-current protection mit 131 - single pole directional over-current protection with dc transient free high set application distribution feeders transmission lines solidly or resistance grounded systems

• Frequency: 60 Hz
• Model No: MI-SS-212D
• Brand: Good Sky
• Protect Feature: Sealed
• Theory: Solid State Relay
• Coil Type: 12 V DC

• Brand Name: Avana
• Rated Voltage: 110 V AC

• Control voltage: 24V DC ±20%
• Unit current: <20mA @ 24V DC
• Indication: Orange / Yellow
• Protection: Reverse polarity
• Interval time delay: 1 - 15 Secs (Adjustable)
• Time delay setting accuracy: ±20%
• OUTPUT:  
• Supply voltage: 24V DC ±15%
• Indication: Green LED
• Load current: 2A
• Protection: a) Short circuit of load
•  : b)Inductive load dump Protection
•  : Mounting

• Brand Name: Rishabh Instruments
• Voltage: I/P 600V L-L
• Usage/Application: Control Panel
• Model Name/Number: Rish Relay V
• Type: Undervoltage relay
• Current: 5A
• Accuracy: 0.5
• Ambient Temperature: -10 to +55 Deg C
• Approval: CE,ROHS,UL
• Breaking Capacity: 2X Rated Value for 1Sec
• Contact Configuration: 5A 250V AC/ 30V DC
• Power Supply: Aux 230V AC/DC or 60-300V AC/DC
• Protection Category: IP 20 (Front Face only)
• Weight: 300g Approx