Electronic Test Instruments Dealers in Kasturi Nagar, Bangalore

  Actuator Test System consists of actuator test electronics, test rig and data acquisition / analysis system. This system acquires various data from the feed back system and the control signals of the actuator and these are used for further analysis of the system. System Controls have provided effective solution for data acquisition and analysis during actuator dynamic. This is ground test equipment providing different control signals to the actuator. Safety features are provided to monitor the threshold levels of various parameters and render protection against malfunctioning.  

• Connector Type: OBD

Can (controller area network) data logger is a standalone data collecting unit, which can collect and store the data from can bus by sending appropriate queries. It has storage capacity up to 16 gb, to store captured data. The device supports communication rate from 20 kbps to 500 kbps.

• A/C output: BNC Connector for amplified output
• Input Connector: BNC(F)
• Frequency: 1000Hz +/- 10%
• Power: 230 Volts AC, 50Hz, mains supply

VSWR meter is a high gain, Voltage Amplifier tuned at the centre frequency of 1 KHz. It is used for measuring voltage standing wave ratio, attenuation and total mismatch on the line

battery formation equipment, hydraulic forklift

Video Microscope, Rigid Borescope

rpv miniature data logger