Flow Tester Dealers in Bangalore

The melt flow index tester is designed keeping in mind the standards of astm - 1238 and therefore can be easily relied upon for its working and efficacy. The melt flow index tester that we design with high accuracy is again tested on varied parameters so as to attain complete customer satisfaction regarding its quality. applications : plastic molding industryplastic granule manufacturers suitable for : verifying the melt flow characteristics of raw material.

We manufacture state of the art low cost Electronic Leak and Flow Testers. Our leak testers can be used for testing automotive / pneumatic / hydraulic / medical components.  We also design and manufacture complete leak testing machines as per customer requirement.

• Pressure sensor: Differential pressure sensor, gauge pressure sensor (test pressure)
• Pressure ranges: -1,000 bar • 150 mbar • 1,000 mbar • 6 bar
• Measurement range: 55 ml/h to 115 l/min (depending on the laminar flow element)
• Result units: ml/min, ml/h, l/min, l/h, mbar*l/s
• Pressure controller: Mechanical
• Test mode: Direct or indirect test method, exponential extrapolation, bypass
• Dimensions: 345 mm x 145 mm x 435 mm (W x H x D)
• Typical applications: Tests of valves, exhaust gas systems, pipes, membranes

The flow tester CETATEST 915 is used to measure the flow using compressed air. The device contains a measurement system consisting of a laminar flow element (LFE) and a differential pressure sensor. In the direct test method the air, provided by the internal pressure regulator, flows through the measuring section before it enters the test part. In the indirect test method the measuring section is located behind the test part. Due to the special design of the measuring section a laminar flow is generated. The resulting pressure difference is directly proportional to the volume flow.