Heating Furnace Dealers in Malleswaram, Bangalore

Furnaces for die casting machines are manufactured by Silcarb. These Furnaces can be used for both melting and holding Aluminum. Various combinations of heat sources are used, the preferred heat source combination for melting is fuel fired and holding being electric. This combination gives the best results in terms of burning losses, fuel efficiency and temperature accuracy. Output ranging from 150kgs per hour up to 1500 kgs per hour are manufactured by Silcarb.

Silcarb Recrystallized Pvt Ltd is one of the top global award winning manufacturer and supplier company of reverberatory furnaces since 1985.Silcarb manufactures Reverberatory Furnaces as per customers requirements and up to capacities of 10000 kgs. Reverberatory Furnaces for scrap melting are manufactured by Silcarb. Silcarb also does 'on site' installation and rework of Reverberatory Furnaces.

• Stainless Steels: SS420, Stavax(ESR),Mirrax etc

It is a heat treatment wherein a material is altered, causing changes in its properties such as strength and hardness. It is a process that produces conditions by heating to above the re-crystallization temperature and maintaining a suitable temperature, and then cooling. Annealing is used to induce ductility, soften material, relieve internal stresses, refine the structure by making it homogeneous, and improve cold working properties. Machining induces stresses in parts. The bigger and more complex the part, the more the stresses. These stresses can cause distortions in the part long term. If the parts are clamped in service, then cracking could occur. Also hole locations can change causing them to go out of tolerance. For these reasons, stress relieving is often necessary. Tempering is a process done subsequent to quench hardening. Quench-hardened parts are often too brittle. This brittleness is caused by a predominance of Martensite. This brittleness is removed by tempering. Tempering results in a desired combination of hardness, ductility, toughness, strength, and structural stability. Tempering is done immediately after quench hardening. When the steel cools to about 40 ºC (104 ºF) after quenching, it is ready to be tempered. The part is reheated to a temperature of 150 to 400 ºC (302 to 752 ºF).

reverberatory furnaces, Tower Melting Cum Holding Furnaces