Industrial Demolition Services in Hrbr Layout, Bangalore

• Service Type: Silent Demolition
• Service Mode: Demolition using Non-explosive chemical
• Demolition Type: Residential
• Demolition Part: Specific Part
• Demolition Area In Square Feet: Selective place for renovation
• Material Removal Support: Yes

Residential properties are also required to be demolished at times. It can be due to various reasons but what is important is the process that will be followed to get rid of a structure. However, unlike commercial structures, residential structures are usually surrounded by other houses which need to be protected at any cost. We at Demolition Expert have done this a thousand times. With our residential demolition services, you can rest assured that only the mentioned structure will be demolished without impacting its surrounding. For us, it is a cakewalk as we have been doing this for a long time which makes us experts in the job.

We have immense expertise in rendering hassle-free, cost effective and quality-centralized Concrete Demolition Services to our esteemed patrons. The offered services of Concrete Demolition are rendered under the supervision of proficient personnel who make use of different and effective techniques for rendering these services. With us, clients can stay completely assured for timely completion of the assigned task and reasonable charges.

• non explsive: rock cracking

We are offering silent demolishers-novablast. thank you very much for your enquiry for rock blasting. we can take up complete contract or supply of rock cracking chemicals which comes in 5 kgs packets with one box of 20 kgs the usage instruction is as follows. drilling 1. Drill holes using an air hammer drill and appropriate drill bit specific to the rock type. 2. Holes should be drilled no further than 30-60cm (1 ft-2ft) apart. Note. In reinforced concrete recommended no more than 20cm (8") apart. 3. Recommended hole diameter 38mm-50mm (1 1/2" - 2.0") . Depth would be 70-90% of the way depending on the type of rock/material to be removed. mixing 1. For regular safety reasons and mixing small amounts by hand, it is recommendable to use rubber gloves. 2. In a bucket, combine 1.5 liters of water to one 5kgs bag of cracking material .or pour water and cracking material as a rate of 1.3 units by weight. 3. Mix well, using a drill and paddle is recommended . If mixing with a stick or other method, make sure powder is completely dissolved into the water. mix to the slurry. filling 1. Clean holes before filling using air hose remove excess dust from drilling. 2. Cracking slurry should be poured into holes within 10-15 min, after mixing. Do not fill to the top , only fill the holes about 15mm (1/2" to 1 ) from the top. 3. Mix well and pour into holes while agitating the hole to make sure no air gaps are in the hole. Example; using a piece of rod or stick to poke holes. 4. For horizontal holes, a grouting pump would be most reliable to poor. cracking or cutting time the cracks appear in 40-60 min after filling , depending on the weather, rocks, and concrete type. The cracks become wider within time (maximum 48 hours expanding time). no licence required to use it

Electrical Connector

demolition work, Commercial Complex Construction