Industrial Furnace Dealers in Basaveshwara Nagar, Bangalore

We are offering tower melting furnaces. the tower melting furnaces are that shaft furnaces that is used for melting aluminum. These are fabricated keeping in mind the requirement of operation. The furnaces are able to provide the per hour output of 3000 kgs and are available in capacities ranging from 500 kgs to 1000 kgs. we use only best quality casting material and back-up linings. To ensure clients satisfaction, we also manage client visit during the process of casting furnace.

• furnaces range: 200kgs

Crucible Type Tilting Furnaces For Copper with energy efficient Silicon Carbide Heating Elements as the heat source. These furnaces range from 200kgs of aluminium up to 1000kgs of aluminium. Copper furnaces from 200kgs up to 1 Ton capacities

• Stainless Steels: SS420, Stavax(ESR),Mirrax etc

It is a heat treatment wherein a material is altered, causing changes in its properties such as strength and hardness. It is a process that produces conditions by heating to above the re-crystallization temperature and maintaining a suitable temperature, and then cooling. Annealing is used to induce ductility, soften material, relieve internal stresses, refine the structure by making it homogeneous, and improve cold working properties. Machining induces stresses in parts. The bigger and more complex the part, the more the stresses. These stresses can cause distortions in the part long term. If the parts are clamped in service, then cracking could occur. Also hole locations can change causing them to go out of tolerance. For these reasons, stress relieving is often necessary. Tempering is a process done subsequent to quench hardening. Quench-hardened parts are often too brittle. This brittleness is caused by a predominance of Martensite. This brittleness is removed by tempering. Tempering results in a desired combination of hardness, ductility, toughness, strength, and structural stability. Tempering is done immediately after quench hardening. When the steel cools to about 40 ºC (104 ºF) after quenching, it is ready to be tempered. The part is reheated to a temperature of 150 to 400 ºC (302 to 752 ºF).

Exposed Heating Elements-type, with Certi. & Traceability with Digital PID Control, Short Heat-up Time, Ceramic Fiber, 4-Side Heating, with Ceramic Fiber Plate, 3~63 Lit.

lpg burners, Gas Stoves, Wood Fired Gas Stove, Silk Processing Tubs

Hot Blast Valve, Miniature valves, tank valves, Steam Traps

Tower Melting Cum Holding Furnaces, reverberatory furnaces

Car Bottom Furnace, Kitchen Towel, Pot Holder, Oven Gloves, racks

Induction Gold Melting Machine, Induction Heater, Induction Forging

Industrial Furnaces, Ceramic Heaters, industrial kilns, Industrial Ovens