Industrial Oil Dealers in Vithalwadi, Bhavnagar

Test type method specifications relative density at 1515 ℃, gml p: 16 or 32 to be reported water content, %v p: 40 max 1.0 flash point (p.m.c.c), ℃ p: 21 min 60 viscosity (kinematic) @ 50℃, cst p: 25 max 380 sulphur, %w astm d:4294 max 4.0 acidity (inorganic), mg kogg p:2 nil sediment by extraction, %w p:30 max 0.25 ash, %w p:4 max 0.1 gross cal value (calculated) kcalkg p:7 to be reported note: fuel oil for marine users in diesel engines shall not exceed a limit of 0.99 recognising the necessity for low sulphur fuel oil in some specialised uses; a lower limit may be specified mutual agreement between the buyer and the supplier. Conforms to bis specifications, is : 1593 - 1982 for furnace oils - mv2 in addition to the above, bpcl follows the specifications for better customer satisfaction. Sulphur, %w (for export purpose) ip336 max 3.5

St-83a environmentally acceptable lubricant for stern tubes marine hydraulic systems biodegradable marine lubricant not oil but lubricant kemel st-83a characteristics 2013 vgp of us epa st-83a meets the eal (environmentally acceptable lubricant) specification in 2013 vgp of us epa. Base fluid polyethlene glycol, a type of polyalkylene glycol, is well known as non-toxic material. It is generally applied in cosmetics and medicines. Biodegradable oecd 301c test method found st-83a readily biodegradable. Kemel st-83a non-toxic st-83a has been classified as harmless to aquatic lives under oecd 201, 202 and 203 tests. Non-bioaccumulative st-83a is not bioaccumulative to aquatic lives because it is water soluble. No sheen no sludge st-83a is water soluble and forms no sheen or discoloration to the water. Also produces no sludge or emulsion under water surface. High seawater tolerance st-83a provides excellent lubrication and corrosion prevention even when the seawater content is 10%. Seal compatibility for stern tubes, kemel special seal of advanced fluoro-rubber should be applied. Regular viton seal is not compatible with st-83a. Comparison of base oils for eal’s    base oil polyalkylene glycol vegetable oil synthetic ester non-sheening water tolerance good good poor poor poor poor patents granted in us (#7666822). Remarks 1) st-83a absorbs water contained in air. Piping design should be consulted with kemel. 2) normal paints cannot be used with kemel st-83a. Inorganic zinc primer should be used. st-83a environmentally acceptable lubricant for stern tubes marine hydraulic systems product data formula base fluid polyethylene glycol typical properties 1) physical and chemical properties appearance pale yellow liquid viscosity at 40oc 86 mm2s viscosity at 100 oc 15 mm2s density at 15 oc 1.13 gcm3 pour point -8 oc flash point 225 oc (coc) solu.

Hydraulic Oil, Hydraulic Motors, Hydraulic Pumps, Turbochargers

petro coke, ldo, Lubricating Oil, Petroleum Products

kayakalp oil

Dg Sets

Hydraulic Oil, Engine oil, Four Stroke Engine Oil, Gear Oil

Diesel Oil, Engine oil

Grease, Rotary Gear Pump, Water Pump

Marine Machinery, Electric Motor, Marine Engine Spares

Rubber Process Oil, table wax