Calibrators Dealers in Kundrathur, Chennai

PHASED ARRAY UT NAVSHIPS TEST BLOCKDescription: The Phased Array Navship Test Block is used to determine sensitivity levels, fault depth, and distance amplitude correction.Geometry: Four (4) 1/16" (.0625) in diameter angled holes at 30°, 45°, 60°, and 75°. 18 holes on a 1" radius, each.040" in diameter. The last two holes in the array are separatedby 2.5° and have an angular spacing of 5.0°. 18 holes on a 2" radius, each measuring 5/64" (.0781) in diameter.The last two holes in the array are separated by 2.5° and have an angular spacing of 5.0°. 16 holes on a vertical column, each.040" in diameter and spaced.120" apart. 12 holes in an angled row, each measuring 1/16" (.0625) in diameter and spaced.200" apart. a centerline tick mark that has been machine-engraved.Material : Carbon steel,Stainless Steel,Titanium,Aluminum,Alloy Steel.

The instrument serves the calibration of gauge from 0.5 to 100 mm length. The slip gauge to be measured is compared with reference master whose deviation at center is exactly known. With two measuring probes, one at the top and the other at the base plate, this differential measurement gives reliable measurements with extremely high accuracy. A template profile allows the probes to trace 5 points on the surface of the slip gauge under test and one at the center point of the reference master. The manual remote control allows to move the slip gauge smoothly without jerk and interference from body heat. The instrument comes in two versions: Manual and Computerized.The computerized version allows quicker inspection its user-friendly interface and intuitive design. The calibration conform with the requirements of National and International Standards i.e. IS-2984 of 1981 and DIN-861 of 1988.The following features are determined in accordance with the specifications of the standards: Center deviation. Parallelism by measuring at 5 points, and Thereby selection of the Grade. The system is useful in the calibration laboratories which are officially approved by the National Accreditation Board.

• Type: Chemical Injection Skid

our products we work with variety of raw materials including carbon steels, stainless steels, aluminium zinc, & copper alloys and produce forgings, castings, bar stock components, sub-assemblies to stringent specifications. we deploy high grade material, technologically advanced machines & techniques in the manufacturing process and produce heavy engineering parts, fully machined sub-assemblies, critical components to close drawing tolerances and surface finishes. Our range is offered in various technical specifications and is known for their reliability, cost effectiveness & compliance to industrial standards.

Range : 50 to 600°C • Accuracies :  ±0.1% F.S. +1 digit (ETC 600); ±0.15% F.S. +1 digit (ETC 600-2) • Cost Effective – Economy Model • Immersion Depth : 110 mm (ETC 600); 190 mm (ETC 600-2) • Calibration at Site, Fast & Reliable • PD Temperature Control • Analog Output • Switch Test facility • Interchangeable Thermowell Inserts, Single / Multihole

temperature calibrators, stirred baths, sub zero temperature calibrators