Cantilever Gates Dealers in Chennai

These gates are very similar to the conventional sliding gates, except that these gates do not need the ground track for the gates to move on. The advantage of a Cantilever Gate is smooth, quiet operation, vehicle does not experience any bumps and gate is not prone to getting blocked by leaves or dust hence reduced maintenance. Cantilever Sliding Gates are approx. 1/3 longer than a tracked sliding system. This added length acts as a counterbalance so that the gate is free to slide back and forth, thus supported throughout the entire opening and closing width by the roller wheels contained within the bottom track rail. 

Engineered to meet the extreme demands of large openings, BGI's heavy-duty Cantilever Sliding Gate have been supplied with spans of up to 30 meters to close 60 m wide border crossings. The gate moves over steel roller bearings fitted on a carrying frame, which allows the wing to hover above the ground and move across sloping or uneven surfaces without the need for a track.

       Smooth noiseless functionEasy manual over ride incase power failureAdjustable torque IP level 54For safety auto Stop & auto reverse facility with advance control unitIn built Control unit with internal Thermal SwitchModel Available from 400 kg to 2000 kg Capacity Up to 10 meters

Application: linear operator Swing-3000 for swing gates with leaf weight up to 400 kg and width up to 3 m; operator Swing-5000 — for gates with leaf weight up to 500 kg and width up to 5 m. Advantages: the lead screw of high strength steel has improved kinematic characteristics; telescopic lever system; smooth ride and low noise operation. Installation: the installation of the operator is made using bolted joints; there is no need of welding, which greatly simplifies the installation process; the kit includes all necessary mounting brackets and fastening screws. Design: the operator is made of high-strength aluminum alloy and protected from any kind of negative environmental effects.

Cantilever sliding gate systems do not require a ground track - this can be advantageous where the driveway entrance slopes, busy or heavy traffic entrances or where minimal disturbance to the driveway surface is requested. The main design difference from a tracked system is that the cantilever system has a special section bottom rail in which incorporates two sets of enclosed roller wheels set apart at a pre- determined distance  to a large concrete foundation base. The cantilever sliding gate is approx 1/3 longer than a tracked slider, the extra length acts as a counterbalance so that the gate is free to slide back and forth, supported throughout the entire opening/closing width by the roller wheels within the bottom rail. There is a slam post assembly at one end and stops at the other end to ensure that the gate cannot slide free of it mountings and fall over.  Often the lower leading edge has a wheel which engages into a guide/shoe to ensure correct engagement upon closing. The gate is held up-right by a guide rail and a roller. Guides positioned at the mid or top rail height. In the manual mode the gate is very easy to slide open and closed as the roller wheels incorporate precision bearings. The method of automation is based on a rack and pinion principle, the motor unit has a drive gear which engages into a linear rack positioned on the lower inside face of the gate, the motor gear wheel simply drives the gate open and closed. The motor incorporates a electronic controls which can be set up to the correct closing force and open/close positions. It can also provide a smaller opening aperture to allow pedestrian only access if required.

Cantilever Gates, Swing Gates, humps doors, Dock Levellers

Industrial Cantilever Sliding Gate, Roller Door Shutter