HTL Limited Guindy, Chennai, Tamil Nadu

Unarmoured cables used as the backbone in Outside Plant (OSP) environments to be installed into ducts underground either by blowing or pulling methods. These cables can be laid along with high voltage lines inside ducts due to their dielectric nature. A wide range of cables are available as per the specific environmental conditions of cable deployment.These cables are recommended for duct installation. They are easy to install and have a rugged PE outer sheath with strain free fibers due to S-Z stranding and loose tube design. Longitudinal water blocking compounds in tube and core. These have easy mid span access.  

Micro cables are meant for use in micro ducts by air blowing techniques. The small outer diameter provides the required rigidity & flexibility for blowing/pushing through ducts. Its lower minimum bending radius makes it easy to operate and splice. Micro cables are used for laying in broadband and long-haul network in areas having confined spaces clogged with cables and open to further disruptive upgrades of the network Micro cables offer flexibility of upgrading a network that can quickly grow and change. Micro cables are meant for use in micro ducts by blowing. Its small outer diameter provides the required rigidity for blowing/pushing through ducts offers lower minimum bending radius.These cables have small dimensions and hence are highly flexible and are recommended to be blown in micro ducts or existing ducts enabling simpler network planning. Such cables are used where confined spaces clogged with cables and disruptive upgrades are a concern. .  

FTTx cables consists of group of cables for indoor & outdoor applications. These cables are used to connect the external networks to the subscribe building.Drop Cables are designed for quick installation and serve as the last link in aerial and building applications. Drop Cables are designed for quick installation and serve as the last link in aerial and building applications. Simplex/Duplex cables are designed for short run indoor applications. These cables are used in the manufacture of patch cords. Fibers to the Antenna or FTTA cables provide connection between the base station and remote radio unit. These cables have good crush resistance and bending performance. Flat drop cable offers ease of installation of standard loose tube cable in an easy access loose tube design. The dielectric element eliminates any grounding requirement.  

Armoured cables are installed in Outside Plant Applications (OSP) suitable for indoor duct or direct buried installations. The cable has a very high compressive strength & the armoring provides protection against rodents and other types of likely mechanical damage. Available in a variety of designs such as non metallic steel tape & steel wire armouring cables. Steel wire Armoured cable makes cables rugged to be suitable for direct burial with excellent cursh resistance and full rodent protection. Used in areas where mechanical impact on the installed cable is to be expected. Armoured Fiber Optic Cable Series are suitable for direct burial applications as well as duct applications. Corrugated Steel tape armoured cables are designed specifically for use in areas requiring a high degree of mechanical protection. The cables are extremely rugged and provide good rodent protection. Glass Yarn Armoured Fiber Optic Cable Series are meant for duct applications. Dielectric strength member – Glass Yarn, gives protection to the cable against rodent attacks. Because of their dielectric nature cables can be laid along with high voltage lines inside ducts.    

Aerial cables are best suited as backbone in overhead applications. These cables offer reliable transmission over a broad temperature range. They can be installed either pole-to-pole, or lashed to existing infrastructure available for long medium & short span routes.   All Dielectric Self Supporting Fiber Optic Cable Series are suitably designed for installation on poles in distribution and transmission environment where live wire installation is required. These cables are designed based on required span length and the prevailingFigure 8 self support cables are designed for use in aerial applications as an alternative to lashing. An integrated messenger wire support provides the necessary tensile strength and the outer sheath is extruded in the form of figure of 8.