Indian Power Press Engineers Muggappair, Chennai, Tamil Nadu

We are offering quick die change systems. Press die sets are massive precision components that must move quickly and accurately from presses to storage areas and back again. The system that performs these functions is called a qdc system, or quick die change system. There are many qdc systems used, but the rolling bolster and die cart systems are the most common. Rolling bolster systems: there are three popular rolling bolster systems: i. Single bolster operation: the bolster moves laterally in a straight line into and out of the press. This may be done at either the front, rear, or sides of the press. In this type of system the die is placed onto the bolster in a preset position and manually clamped to the bolster. The bolster is then run into the press bed area and automatically clamped into position. advantages: this system provides a means to easily install a die at a preset position, assure uniform clamping, and also insure uniform positioning in the press.

Another inspection technique used to evaluate and pinpoint problems in power press equipment is "vibration measurement". Vibration techniques are used either to pinpoint an existing problem or to evaluate the health of a system on a routine basis. Mechanical equipment produces vibrations which correspond to its inherent design, the condition of the equipment, and how the equipment is being used. By qualifying and quantifying the information with state of the art methods and instrumentation, reasonable levels of reliable evaluation and diagnosis are possible.

Main cylinder is the most important part of a hydraulic press. Cylinder develops pushing or pulling force required to carry out desired operation, using pressurized hydraulic fluid.

We are offering unsticking presses jammed. The best plan is to work carefully at all times to avoid sticking the press on bottom. Basic diesetting skills such as checking die shut height with a tape measure and adjusting the press shut height on bottom to allow enough room plus a safety factor before setting the die will avoid many problems.