Simplex Type OIL PUMPING AND HEATING SYSTEMS
Radiant type RECUPERATORS
Radiant type recuperators are typically used in forging furnaces and makes use of the principle of radiant heat transfer to heat up the combustion air. This helps improve the efficiency of the combustion system.
...morePre-piped Gas trains
We supple pre-assembled gas trains.
Pilot Burner
oil fired burner system
Self proportioning burners include a single lever control mechanism that simultaneously regulates oil and air flow.
...moreMotorised combination valve
Gas Fired Burner System
These sealed-in, nozzle-mix burners are stable over a wide range of air/gas ratios from large amounts of excess air, to stoichiometric (chemically correct air/gas ratio), up to 50% excess fuel (provided additional air for combustion is supplied to the furnace near the burners). Burners can be ignited at rich, lean, or correct air/gas ratio, then immediately turned to high fire. NOx emissions are low for all air/gas ratios.
...moreDuplex type OIL PUMPING SYSTEMS
Duplex PU without heating
Dual Fuel Burner System
Dual fuel burners can be used in applications wherein the fuel can be either gas or oil.
...moreCoupling Type AIR BLOWERS
In cases where the main drive shaft of the motor and the shaft of the impeller are axially displaced, a coupling drive is used to couple the two.
...moreConvection type RECUPERATORS
Convection type recuperators are typically used in rolling mill applications and makes use of the principle of convection heat transfer to heat up the combustion air. This helps improve the efficiency of the combustion system.
...moreSingle Stage Direct Driven Type BLOWERS
Please refer to the chart in Downloads section for the direction of discharge information.
...moreV-Belt Type AIR BLOWERS
Constant Pressure Valves
gas flow control valves
Oil Flow Control Valves
Air Flow Control Valves
Solenoid Valves
MCC Electrical Panels
Burner Management System Panels
BMS Panel
Be first to Rate
Rate ThisOpening Hours