Metal Ingot Dealers in Mogappair, Chennai

nickel alloy metal, carbon steel ferrous metals, Ferrous Metal

A hard rock, bluish in color, which is crushed and used for construction purposes. The byproduct Blue Metal may replace sand and will be an artificial sand and will be used in construction of buildings. We offer a wide range of blue metal chips that are acquired from our own quarry.        Available Sizes of Blue Metal - Aggergates 1. 20 mm2. 12mm3. 25 mm4. 40 mm5. 6 mm6. Quary Dust (CRF)7. 63/408. 83/1509. Filter Stone 10. Boulders/Soling Stone11. Bond Stone12. Wet Mix13. Dry Mix14. Crusher run15. GSB with dust mix (0-40mm) 16. GSB with natural sand mix (0-40mm) 17. Hill Earth18. Murrum   STANDARDS FOR AGGREGATESAggregates and test methods. These new Standards will change the way in which we look at our aggregates, although the materials will be the same there is a new way of defining aggregate sizes, different sieve sizes with new grading and a new set of tests for physical and mechanical properties. AGGREGATE SIZE (d/D)Sizes are now described using two sieves a lower sized sieve (“d”) and a higher size sieve (“D”) and is now classed as d/D, an old 20mm single size stone will now be classed as 10/20 e.g. “d” equals a 10mm sieve and “D” equals a 20mm sieve. For all-in aggregates “d” is 0.  BS 63                          New EN Size                                Size40mm                            20/4028mm                            20/3220mm                            10/2014mm                          6.3/1410mm                             4/106mm                              2/6.33mm                               1/4  CRF                               0/4 all-inFine Sand                       0/2FP GRADING CATEGORY (Gc) There is now a Grading Category (Gc) which specifies the percentage of material passing d/D, therefore a 10/20 would have a grading category Gc85/20 this means that up to 85% of the material can pass the 20mm sieve (D) and up to 20% can pass the 10mm sieve (d). The grading for a 10/20 Gc85/20 would be Sieve Size                    Percentage Passing40mm                                      10031.5mm                               98 – 10020mm                                  85 – 9910mm                                    0 – 204mm                                      0 – 4 FLAKINESS (FI)The Flakiness test has changed you now use a bar sieve along with the new sieve sizes, the results are lower then the old method and for Asphalts a Flakiness of less then 35 is now acceptable FI35.

metal & non metals, Metal, non metals, industrial gasket

We r doing cc and bc ingots we can give kilograms and ton wise also, our product will be good to use for ur uses

Titanium, Stainless Steel, Stainless Steel Sheet, Pipes, carbon steels rods

blue metals, Building Material, Cement, kappa stone, Sand

Aluminum Ingot, Electronic Equipment, Red Onion, Steam Coal

Copper Wire Scrap, Mild Steel Scrap

Zamak Alloy Ingot, Cadmium Copper, brazing wire, Tellurium Copper Rod

iron ingots

Metal Ingot

blue metals, PSAND, msand, blue metals, Door to Door Delivery

Zinc Ingots, Brass Scrap, Cable Accessories, Copper Cathodes