Back Back
Pin And Disc Wear Apparatus
75,000 Per piece
The Pin And Disc wear Apparatus consists of a steel disc whose top surface is case hardened and ground. The disc is rotated by a single ph. Induction motor at 3 different speeds. The test pin is inserted in a pin guide so that one end of pin touches the rotating disc. The pin guide is mounted on a cantilever to which spring balance is attached.The pin is inserted in the pin guide. The disc is set to rotate at the required speed. The required load is put over the pin and wear of the pin is measured for a time interval of 5 minutes. Different materials can be tested at different speeds, bearing pressures and either lubricated or non lubricated form.
Pin Fin Apparatus
Get Price Quote
The apparatus is designed to calculate the heat transfer rate from the fin and the fin effectiveness in natural & forced convection. The apparatus consist of a pin type fin heated by a band heater at one end. It consists of a channel in which the pin fin is tested in both natural as well as forced convection. A centrifugal blower draws air over the fin. The blower is operated to touch the pin fin in forced convection only Thermocouples are attached along the length of fin to note down the longitudinal temperature gradient. Product Code : SAMS HTL - 005
Best Deals from Pin Fin Apparatus
Pin Fin Apparatus
26,500 Per Piece
