Programmable Microcontroller Dealers in Chennai

The LilyPad Iduino can be programmed with the Arduino software . *Note*, the LilyPad Arduino should only be programmed with software versions 0010 or higher. You can program it with earlier versions, but all of the time related functions will be off (twice as slow as they should be). The ATmega168V or ATmega328V on the LilyPad comes preburned with that allows you to upload new code to it with the Arduino software. You can also bypass the bootloader and program the ATmega through the ICSP (In-Circuit Serial Programming) header. FEATURE Microcontroller ATmega328V Operating Voltage 2.7-5.5 V Input Voltage 2.7-5.5 V Digital IO Pins 14 (of which 6 provide PWM output) Analog Input Pins 6 DC Current per IO Pin 40 mA Flash Memory 16 KB (of which 2 KB used by boot loader) SRAM 1 KB EEPROM 512 bytes Clock Speed 8 MHz

• Features: High performance, Need no maintenance , Excellent design , Easy to install.
• Pay Mode Terms: L/C (Letter of Credit)

The Arduino Uno R3 is a open source microcontroller board based on the ATmega328 chip. This Board has 14 digital inputoutput pins, 6 analog input pins, Onboard 16 MHz ceramic resonator, Port for USB connection, Onboard DC power jack, An ICSP header and a microcontroller reset button. It contains everything needed to support the microcontroller. Using the board is also very easy, simply connect it to a computer with a USB cable or power it with DC adapter or battery to get started.The Uno differs from all preceding boards in that it does not use the FTDI USB-to-serial driver chip. Instead, it features the Atmega16U2Atmega8U2 up to version R2) programmed as a USB-to-serial converter. While the Arduino UNO can be powered via the USB connection or with an external power supply, the power source is selected automatically.External (non-USB) power can come either from an AC-to-DC adapter (wall-wart) or battery. The adapter can be connected by plugging a 2.1mm center-positive plug into the board's power jack. Also leads from a battery can be inserted in the Gnd and Vin pin headers of the Power connector. The board can operate on an external supply of 6 to 20 volts. If supplied with less than 7V, however, the 5V pin may supply less than five volts and the board may be unstable. If using more than 12V, the voltage regulator may overheat and damage the board. The recommended range is 5v to 12v for Arduino Uno.

ARM 2129 Development Board ARM 2148 Development Board PIC16F877A Development Board PIC16F628A Development Board PIC16F628A Development Board

Microcontroller Development Board, Laboratory Products, Workshop Equipment

CPLD Development Board, NXP 89V51RD2 Embedded Development Board

DC Drives, Stepper Motor Drive, Programmable Logic Controllers

Uninterrupted Power Supply, Voltage Stabilizers