Compressed Air Dryer Dealers in Coimbatore

• Voltage: 220V
• Condition: New
• Finishing: Polished
• Packaging Type: Carton Box
• Power Source: Electric
• Warranty: 1 Year
• Brand Name: Frank Compressors

Refrigeration Compressed Air Dryer (Nippydry) Principle of Operation Warm compressed air enters the Air / Air Heat Exchanger where it is precooled by outgoing cold dry air. The pre-cooled air enters the Air to Freon Heat Exchanger where it is cooled down to +3°C.   At this temperature, water condenses into liquid droplets, which are removed from the air stream by a very efficient Demister and automatically discharged by a Automatic Drain Valve.   The cold dry compressed air passes back through the secondary side of the Air to Air Heat Exchanger where it is reheated by the incoming warm air.   Features Dewpoint +3°C Designed for high ambient temperatures Advanced 3 in 1 heat exchanger for low pressure drop. Time delay for compressor safety Intelligent controller

Heatless Desiccant Dryers different other applications of gas andor air dryers involve the use of Heatless Compressed Air andor Gas Dryer systems. High Pressure Gas and Air Drying Systems also involve the use of these compressed air and gas dryers in many of their applications.

We offer compressed air dryers. Heatless type desiccant air dryers, heated type air dryers, refrigerated type air dryers, condensate sensing type zero air loss auto drain valves, timer based auto drain valves, mechanical float type auto drain valves ,compressed air micro filters ( 0.1 ,0.001,0.0001 microns), activated type carbon filters, moisture separators,air receivers, air compressors,medical air compressors, medical vaccum pumps, dental air compressors, etc.

• Desiccant Material: Silica Gel
• Dryer Technology: Dessicant
• Bowl Size: 6.7 lb
• Maximum Pressure: 250 psi
• Application: Dry Air
• Drying Capacity: 21 - 50 cfm
• Application: Dry Air
• Air Inlet Temperature: 120 F

Function: Used for evaporation, dryer, demisting Material of Construction: AluminumStructure: Bar and Plate Heat Exchanger Specialty: High Heat Transfer ability , Energy-Saving Heat Exchanger Application: Air Dryers General Process: 3-in-1 and 4 in 1 heat exchanger and water-oil separator model is designed specially for the Refrigerated Air Dryer. It consists of Precooler (Air to Air Plate Fin Heat Exchanger), Evaporator (Air to Refrigerant Plate-Fin Heat Exchanger) and stainless steel mesh Gas-Liquid separator filter. It has four functions: Precooling, Cooling, Separation and Filtration. There is insulating layer outside of this unit in order to reduce the loss of heat and increase the effectiveness. Precooler and Evaporator are both aluminum vacuum brazed Plate-Fin Heat Exchangers. Compared with shell and tube heat exchanger in traditional refrigerated air dryer, the heat transfer area of plate-fin heat exchanger is larger and so the exchanger effectiveness is higher. Generally, the heat transfer area density of plate-fin heat exchanger can be 1500m2/m3, but the shell and tube heat exchanger’s is only about 160m2/m3. And the heat transfer coefficient of plate-fin heat exchanger is 5-10 times higher than shell and tube heat exchanger. Air-water separator uses optimized spiral guide structure and the main principle is to separate the liquid and gas according to the difference of the liquid weight and gas weight and using gas flow direction and the inertia of speed changing. Mesh filter is made of some steel mesh and it can filterate air secondary to increase the dry efficiency.   Features and Advantages（1）Compact size:- Reduces the total air dryer size- Significantly reduces the refrigerant hold-up volume（2）Highly efficient thermal performance and low pressure drop minimizes power usage.（3）Low price.（4）Easy to repair and long service life.（5）Full compatibility with the most common refrigerants. TestingAll of our 4 in 1 heat exchangers undergo a hydrostatic test of 1.5 times the design pressure with water for 30 minutes and a leak test of 1.1 times the design pressure with air for 10 minutes for the air side. After passed by the above tests, each unit is to perform 24 hours’ keeping pressure of 18 bar and conduct helium test for the refrigerant side, respectively.

• Features: Long functional life ,Sturdy construction ,Negligible maintenance

Refrigeration air dryer . Used to control moisture that comes out of air compressor.it is available from 20 cfm - 2000 cfm. It is used in all type of pneumatic machineries used companies , eg: knitting , powder coating , color sorting , spinning mills , pet bottle machineries , service stations , etc

• Country of Origin: India
• Type: Refrigerated
• Voltage: 415 V
• Frequency: 50 Hz
• Drying Capacity: 40 cfm
• Dryer Horse Power: 2 HP
• Minimum Output Dew Point: -40 C
• Maximum Pressure: 18 Bar
• Air Inlet Temperature: 90 Degree Celsius
• Power Watt: 800 W
• Dimensions: 16x16x12 Inch

We present our clients with an extensive range ofHeat-less Air Dryers that are available in varied specifications. These products are considered as one of simplest of all desiccant based air dryers. The use of these Heat-less Air Dryers facilitate in passing thecompressed air through adsorption tower filled with desiccant (Activated Alumina/Silica Gel/ Molecular Sieve). Furthermore, desiccant helps in absorbing the moisture present in the compressed air. During the preset time, tower gets regenerated by purging small quantity of dry air.   WE ARE THE LEADING MANUFACTURE IN HEATLES AIR DRYERS & ALSO SUPPLIER IN TAMILNADU(Chennai, Coimatore, Trichy , Madurai, Salem, Erode, Thirunelveli, ) KERELA( Cochin, Thiruvanathapuram, Palghat, Calicut, KARNATAKA, ANDHRAPARDESH  

Compact Steel Cabinet,Maintanance free multiple - stage condensate seperator,Solid state timer operated drain trap,Solid state information system, Consisting of three digit LED temperature display with operating range from -20o C to +100o C,Service gauge for refrigeration suction pressure,Air-to-refrigerant heat exchanger with smooth surface copper tubes,Air-to-Air heat exchangers with smooth surface copper tubes.

We are offering desiccant air dryers with Tower pressure guages,Highly accurate motorized cam timer.

Heatless Air Drier with pre-filter, oil remover filter, after filter, bypass line fully assembled and supplied as a single system of a common base frame. 100% oil and moisture free compressed air at the outlet of air drier with a Dew point of -40° C. special features: Reusable ceramic filter elements with 5 micron rating are used in pre filter and after filter.  range: Up to 2000 cfm at 12 kg/cm² working pressure. High pressure models also available.

• Capacity: 100 to 10000 m3/hr

air contains contaminants like solid (dust particles), liquid (moisture) and oil which contaminates the compressed air. When this contaminated compressed air is used for various applications, it may cause failures of pneumatic valves, instruments, etc which results in the downtime of whole system.   summits heatless air dryers remove the moisture to a level of 80 ppm(w) by using pressure swing adsorption technology. The wet air enters into one desiccant tower and gets dried by the high performance desiccant adsorbent. The dry air passes through check valves and post filter to the utility. A portion of dry air (depending on the operating pressure and required dew point temperature) passes through an orifice into the other saturated tower at near atmospheric pressure, liberates the entrapped moisture in the desiccant to the atmosphere and regenerates it for the next drying cycle. A reliable electronic timer controls the cycle and valve operations effectively therby ensures continuous dry air output to the utility.   salient features   • proven trouble free valve design • rugged carbon steel construction • integerated pre & post filters • easy and flexible installation • simple maintenance • outlet air quality according to iso 8573-1,table 3,class 2 & 3     Applications   • plant air • painting process • cnc machines • hospitals • food & processing • textiles • leather industry • automobile industies

Air discharged by any air compressor always contains water vapour, which also depends on the ambient temperature and the relative humidity. When air is compressed, the volume decreases proportionally. This results in condensate formation. Condensate causes corrosion in compressed air pipe line. Compressed air driers are used to separate the condensates. Refrigerated Air Dryer removes moisture from compressed air to the desired dew point temperature. The performance of a dryer is quoted in terms of ‘pressure dew point’, which is the temperature at which water vapour will start to condense out of the air. For example, a dew point of 4ºC at 7 bar (g) (700kPa (g)) means that no water will condense from the air until it goes below a temperature of 4ºC. Working principle: The saturated compressed air enters in air-to-air heat exchanger. Here the incoming hot air is cooled by the outgoing cold air. The pre-cooled incoming air enters in the air-to-refrigerant heat exchanger further reducing the air temperature to specified dew point 2ºC to 4 ºC. The air leaving this evaporator is directed to the cyclone separators and water vapour condensate liquid droplets gets removed automatically by Automatic drain valve.

We manufacture and supply a comprehensive range of excellent quality compressed air dryers. They are manufactured keeping in mind international quality standards. Our compressed air dryer is highly successful in removing water vapor from the compressed air. Excessive water vapor in compressed air causes several problems in industries like corrosion of equipment and pipes, freezing of outdoor air lines etc. Hence, air dryers are essential in commercial and industrial buildings. We check the compressed air dryers for any flaws and for efficiency before dispatching them to the customers. Technical specifications: water flow rate- 10 m³ hr to 500 m³ hr temperature range- 4°cto 30°c

Principle of Operation Warm compressed air enters the Air / Air Heat Exchanger where it is precooled by outgoing cold dry air. The pre-cooled air enters the Air to Freon Heat Exchanger where it is cooled down to +3°C.At this temperature, water condenses into liquid droplets, which are removed from the air stream by a very efficient Demister and automatically discharged by a Automatic Drain Valve.The cold dry compressed air passes back through the secondary side of the Air to Air Heat Exchanger where it is reheated by the incoming warm air. Features Dewpoint +3°C Designed for high ambient temperatures Intelligent controller Time delay for compressor safety Advanced 3 in 1 heat exchanger for low pressure drop.

Refrigerated dryers use of mechanical refrigeration system to cool the compressed air and at the same time condensate water and hydrocarbon vapor, most of these dryers cool the compressed air to a temperature of around 2 deg C which leads to a pressure dew point of 3 deg C. This is the preferred range because it allows the pressure dew point to fall with in the range that is attainable with common refrigeration system control working principle.  

• WHITE: BLUE
• WHITE: BLUE

We are offering refrigerated air dryer.capacity - 20 - 300 cfm.

It is a surprising fact that 100% of the electrical power (energy) is converted to heat energy during the Compression process In an Air compressor & all the heat energy goes as a waste if not used judicially.In a typical compression system, the theoretical recoverable heat is 96% of the overall electrical energy consumption. It consists of heat dissipated in the oil cooler (78%) the aer cooler (13%) and the heat radiated from the drive Motor (5%). The rest 4% heat cannot be recovered since 2% radiates through the canopy and the other 2% vents inside the canopy.