Motion Controllers Dealers in Coimbatore

  PVI,VME & PC104 formates standalone or bus configurable 1 to 32 axes,expandable to 128 axes devalopement tool for pmac application system built with 3 u format motion control board and accessories combination of motion controller and drive

• Brand Name: ESSTEE
• Current: 24mm
• Phase: dia24mm
• Voltage: 350kgf
• Application: Drilling SPM machines to control the feed rate
• Casing Material: MS
• Size/dimension: Max Stroke - 100mm
• Mounting Type: Panel Mount

We make sure the ranges of product we offer purchasers with are as per global quality management standards. As a dependable name, we source raw materials from the well-known providers who are certified. Thus, we guarantee only quality-approved products at customer's end.Features : Operating voltage range 220V AC for ESM-01 and 24V DC for ESM- 02 Contact 2C/O Rated for 2A @250V AC/28V DC Resistive Load LED Indication for supply LED Indication for Relay status Elegant and compact plastic housing meeting safety standard. Din rail mountable Initialization and Settings : Before Installation, Isolate the Supply. Connect the unit as shown in the diagram below. Connect the External terminal points to the ˜E3™ and ˜E4™ terminals. Connect the Earth point to ˜E5™ terminal. Operation : Whenever a fault occurs, the earth point (Machine body) is connected to the sensing point causing a small current of 0.1mA to flow through the unit. This in turn triggers the circuit to operate the relay. External point 2 closes, Relay 2 changes over External point 1 closes, Relay 1 changes over Note : NO/NC function can be selected by connecting the relay in the appropriate terminals as shown in the connection diagram

Salient Features   Spinpro – 9A Speed programmer works with all spinning machines SPINPRO – 9A IN G5/1 Production Improvement observed by 5-15% Displays: Length delivered, Delivery Rate, TPI/TPM, Spindle Speed, No. of doffs, Hanks, downtime, Runtime, Delivery speed, Production kgs and flickering length Optimum Production verses Energy Utilization Less waste & Yarn Breakages Uniform Hanks in Production Maintains set speed at supply voltage / frequency fluctuationsProduction in hanks and Doffs (Shift wise & Total). Spindle Speed, Delivery rate, TPI, TPM, Run time and Down Time are recorded Length based Speed pattern can be set up to 25 steps Speed pattern can be pre-programmed for nine different counts Speed reduction Percentage Ring traveler pattern can be programmed Password control for tamper proof operation Programmable slow speed facility RS 485 Serial port to connect with computer

motion controllers, SCADA Software Development, Precision Turned Components

Wind Speed Display Controller, Thickness Gauge Meter Tester

Bus Speed Controller, Chicken Shawarma Machine