Suction Pump Dealers in Sidco Industrial Estate, Coimbatore

• Pressure: up to 10 Kg/cm2
• Capacity: from 50 lph — 50,000 lph
• Viscosity: as low as 1.0 Centre stoke — 3,00,000 Centre stoke

The principle of operation of our Sanitary Lobe pumps are two synchornized rotors (Lobes) rotating against each other build chambers towards the casing of the pump. At the suction side, the fluid enters the chambers and during rotation, the fluid is displaced in the direction of the volume flow in to the Discharge side     Salient Features High suction capability Ease of maintenance without disturbing pipe assembly Reversible pump Also transfers abrasive partciles in suspension Low pulsation, low noise and high precision metering discharge Smooth quite flow Excellent self priming Intensive to viscosities All metal construction, no contamination Single Sealing, external bearing Low noise and pulsation Reversibility Bracket/Gear Box mounting allows free expansion/contraction-alignment not affected Easy maintenance Slow speeds ensure better pumping and longer life Reduced maintenance Fluids Handled THE INTERNAL GEAR PUMPS ARE USE TO HANDLE THE FOLLOWING CLEAR FLUIDS Furnace Oil Mineral Oil Edible Oil Petroleum GellyPaints & Varnishes Solvents Chemicals Acids Alkalis Hot Syrups    

Salient Features- High suction capability Ease of maintenance without disturbing pipe assembly Reversible pump Also transfers abrasive partciles in suspension Low pulsation, low noise and high precision metering discharge Smooth quite flow Excellent self priming Intensive to viscosities

• Application: Industrial Use

Wettable parts of this class of pumps are made out of SS 304, SS 316 or special Alloys like Alloy 20, Hastalloy. The Rubber stators are of Natural or Synthetic rubbers like Nitrile, EPDM, Hyplon, Silicon, Neoprene, Viton, Butyle and Hi –Nitrile based on end application.

MATERIAL COMBINATIONS OFFEREDHichrome (28 % Cr, 600 - 650 BHN), Nihard & Rubber SALIENT FEATURES Greater wear life Closed / Open Impeller Tangential Discharge Casing Removable Suction & Rear Casing Liners Variable discharge nozzle positions Fixed / Variable speed drive Back Pull-out design OPERATING DATA Max.Working Pressure - 16 (bar) Max.Flow rate - 2500 rnVhr Max.Total Head - 100 mtr Max. Solid Size Dia - 126 mm Min/Max Speed - 720/960/1450 rpm Max. Temperature 180°c   APPLICATIONS All Abrasive Slurries & Sludges Mineral & Ore Processing Cyclone Feed & Under-flow Tailings Disposal Lime & Clay Slurries Classifier & Thickener Under-flow Dewatering, Wash down & Sluicing High Density Slurries & Sludges Coal & Ash Slurries Beach (Sand) Recovery