Surge Protector Dealers in Coimbatore

We are offering voltage surge protectors. Emi filter circuit design to achieve adequate suppression of the spurious noise, filter style or circuit schematic should be first chosen following the rule of thumb of having the capacitor end of a filter facing the high impedance and the inductor end facing the low impedance. Table 2 below illustrates the above circuit selection criteria. The next step will require determination of the working voltage, rated current, maximum dc resistance, cut-off frequency and insertion loss. When specifying working voltage and rated current, any derating requirements should be taken into consideration. Maximum allowable voltage drop will usually govern maximum dcr of a filter. The cut-off frequency is often selected one decade above the frequency of a signal. The insertion loss data throughout the catalog is based on mil-std-220 and provide means of comparison and testing only. Il performance of any given filter could be quite different for systems having actual source and load impedances other than 50 ohms. To help the user get acquainted with this catalog and emi filter design, every effort has been made to organize the data sheets and list the parts in a logical order. Every table starts at the top with lowest voltagecurrent and consequently highest capacitanceinsertion loss characteristics parts. These are followed by higher voltage and naturally lower capacitance and insertion loss performance devices. Our emi filter design catalog provides you with the most comprehensive and widely used selection of emi filters. However, it represents only a cross-section of capabilities. Whether your application requires unique electrical characteristics or customized mechanical configuration, there is a high probability that we will be able to satisfy your specific needs without compromise.

ALYW-F series antenna Surge Protective Device is suitable for satellite TV high frequency, satellite signal receiver, microwave machine station, the feed system of moving communication, which is to avoid the damage to the Receiving equipment caused by over voltage of feed inductance. These series installed at the joint of LPZOB and LPZ1.Used in these systems such as the air port's navigating station,(NDB) long wave communication station, small power of short wave communication BP paging transmitter, closed-circuit TV,Cable TV,VSA satellite TV, satellite receiving station of the securities, microwave communication receiving and dispatch station,MMDS microwave communication and GPS global position system.

• Country of Origin: Made in India
• Model Name/Number: SPD-230V
• Brand: Ulive systems
• Phase: Single Phase
• Usage/Application:  panels,Industrial,Solar power system
• Dimension: 9 x 4 x 5 cm
• Voltage Rating: 230V AC
• Rated Current: 10KA
• Discharge Current: 10000 A

• Voltage Rating: 340-465 V
• Phase: Three Phase
• Brand: Adroit
• Poles Number: 3 Pole+N
• Number Of Poles: 2