Back Back
Hybrid Solar Inverter
Get Price Quote
AMON solar charger along with our inverter will have first priority solar charging. i.e., when it Is charging from solar, it will not charge from the mains. Also, when it is charging from solar and battery Is nearly full charged (for AMON Inverter this voltage is settable in menu), the inverter will start Working by disconnecting the mains bypass. So the solar power will go to the load through inverter and Also charge the battery (online function) if the solar current is more than the inverter current. If solar current is less than the inverter current, inverter will take the balance current from the battery.When the battery reaches the reserve charge (in AMON Inverter this value is settable), inverter will stop And mains will bypass, and the battery will be charged by solar. During nights, if the battery is not Charged from the solar, battery will charge from the mains but only to a certain percent (in AMON Inverter this value is settable) so the next day the battery can be charged from solar. If the battery is Fully charged using mains the previous night then the solar energy during the next day will be wasted.This way the first priority is always given to solar. Features: D.S.P. (Digital Signal Processor) based design. Pure sine wave output resulting in silent operation of motor and fans safe to all kind of loads. Computer compatibility. S.M.P.S Charging up to 120V AC Input. Inverter / UPS Selection Switch. Solar Charging Control Switch. Mains Charging Control Switch - No tension for night charging. Auto Switchover between Solar and Mains. Simultaneous Charging throgh mains as well as solar panel. PWM / MPPT Solar Charge controller.. Solar display for panel voltage, panel current, battery voltage and total generater solar energy in Kwh. Inverter display for mains ON, Mains Volt, Charging ON / OFF, Charging current, battery Volt, inverter / UPS ON/OFF, output volt, output load etc., Protections against over load, short circuit, battery deep / over charging, Mains over volt (upto 440V), phase input & output reverse, phase & neutral reverse, heavy load in all these error conditions will be shown in the LCD display.
