Heavy Duty Plano Miller
Get Price Quote
Cat. No. : WM-018HEAVY DUTY PLANO MILLERFOR BETTER ACCURACY, FINISH AND PRODUCTIVITY, AVALIABLE IN THREE MODLES (a) PLANO MILLER GEAR TYPE(b) PLANO MILLER BELT TYPE(c) PLANO MILLER ELECTRO MAGNETIC DRIVE TYPESPECIFICATIONS L in the Model indicates any length of stroke required between 6' to 40' Width between columns L 3ft. L 4ft. L 4.5ft. L 5ft. L 5.5ft. L 6ft. L 7ft. Length of Stroke in feet 6 ft. to 40 ft. as per order / requirement Length of Stroke in Meters 1.8m to 12m as per order / requirement . CAPACITY Width between colums 900 1220 1372 1524 1676 1828 2133 Height under Cross Rail 900 2300 1372 1524 1676 1828 2133 . TABLE Working Surface Length EQUAL TO LENGTH OF STROKE L No. of T-Slots 5 5 5 6 6 6 7 Width of T-Slots 19 19 19 19 19 19 19 Distance between T-Slots 127 127 148 148 148 190 190 . MILLING HEADS No. of Milling Heads ONE, TWO OR THREE AS PER ORDER Horizontal Traverse of Milling Head on Cross Rail 760 900 950 1200 1350 1500 1760 Max. swivel of Milling Head to either side 50 60 60 60 60 60 60 . CROSS RAIL Vertical Traverse of Cross rail mm (elevating) 750 1200 1330 1500 1650 1800 2060 Elevating Traverse of side Milling Head 600 850 100 1150 1300 1400 1750 . MILLING HEADS GENERAL DUTY OR HEAVY DUTY as per order No. of speeds 6 6 Range of speeds in RPM 55,80,100,130,170,260 50 to 270 rpm Motor 3 phase 440 volts 3 HP/1440 RPM 5 HP/1440 RPM Spindle dia at Nose 85mm 125mm Vertical traverse of quill 70mm 100MM Vertical Traverse operation Hand operated Hand operated Micro Feed Hand operated 1 small division = 0.1 mm One small Division = 0.1mm Feed of Trolly for Milling 32mm to 100mm per minute 32mm to 100mm per minute Cutter Dia 80mm to 10mm 120mm to 150mm Spindle Nose Taper ISO-40 ISO-50 Holding of cutter By Draw Bolt Either by draw bolt / bar or bolts on spindle nose Extra heavy duty milling head with 7.5 / 10 HP also available on request