Oil Coolers Dealers in Mayapuri, Delhi

• handling: 1000 LPM
• capacity: 57000 Kcal/h

These are D Cup Coolers (also known as Bar and Fin Cooler), or Plate and Fin type coolers, typically because cooling fins are attached to the heat sink, thereby increasing its surface area to greater cooling effectiveness.Oil flow handling up to 1000 LPM, Cooling capacity up to 57000 Kcalh.Air cooled heat exchangers oil coolers are lower in cost and maintenance, and can come in very small sizes depending upon the requirement, and still be effective. Water, on the other hand, has a higher specific heat capacity, density and thermal conductivity, and hence has a greater cooling capacity. Furthermore, the water jacket around an engine is very effective in significantly dampening the mechanical noises.

• I Deal In: New Only
• Medium Used: Water
• Usage/Application: Aluminium Die Casting Oil Cooler
• Size: 18" - 48"
• Inlet Temperature: 30
• Cooling Type: Water Cooled
• Outlet Temperature: 90
• Model: SH0318 - SH1048
• Flow Rate: 5 LPM - 2000 LMP
• Diameter: 3" - 10"
• Product Type: Aluminium Die Casting Oil Cooler
• Design Pressure: 20 Bar on Shell Side & 10 Bar on Tube Side
• Shell Dia: 3" to 10"
• Thickness: 1.5mm
• Tubes: Copper Tubes

• Type: Oil Cooler
• Material: Aluminum
• Color: Available in Many Colors
• Application: Industrial
• Warranty: 2 Years,1 year
• Maximum Working Pressure: 20-30 Mpa

Oil is used in a turbine to lubricate important components and to take the heat away from them. Now when this oil is recirculated to the system it has to be cooled down, which is done by oil cooler.We carry out thermal, mechanical design and then manufacture the entire ranges of Turbine Oil Coolers suitable for Turbines of any MW Capacity manufactured by M/S BHEL, Triveni, Bellis, Siemens, Alstom etc for their different capacities Turbines. These Coolers are manufactured as per the codes specified by the customer like TEMA RCB and ASME Codes.We also carry out the re-tubing of the Turbine Oil Coolers on site and at our works too. Re-tubing is done and is feasible in case of large MW turbines only

ACE manufacturers Oil Cooler are specially designed for Rigid applications such as in Stone Crusher, Cone Crushers. Hydraulic oil loses a lot of its characteristic at high temperatures. Heat not only reduces the viscosity and the durability of the oil but it also increases the wear and tear of the hydraulic components of the system.

Air Cooled Fluid Cooler, Hot Water Fan Coil Unit, Cold Storage Room

air cooled fluid coolers, absorption chillers, Gas Turbines

Air Cooled Lube Oil Coolers, air cooled, Air Cooled Condenser

Oil Coolers, Heat Exchangers, Evaporative Condensers, Condensers, CHILLERS

liquid coolers, Meat Cold Storage Plant, Thermocol Pipe Section

Oil Coolers, piston accumulator, minimess coupling, Inline Filters