Soil Testing Equipment Dealers in Adchini, Delhi

Used for detecting the presence of corrosive sulphur in petroleum products.The apparatus consists of a bath either dual purpose (500C & 1000C) or a boiling bath (1000C only) without stainless steel copper strips of definite size 6 or 18 test tubes can be accomodate in each type of bath with different temperature regulation system to operate on 220 volts AC. mains.

To know California Bearing Ratio Test Field Type Values in situ, it is useful in determining the load carrying capacity in the field when in-place density and water contents are such that the degree of saturation is 80 % or greater, when material is conhensionless and coarse grained, such that it is not effected by changes in water contents and when the material has been in-place for considerable time. The loading is effected by means of a mechanical load frames which can be fixed to the under side of a truck. Salient Features Specifications : Mechanical screw loading jack, 10,000 kg. capacity with U-bracket and swivel head. Penetration piston, 50 mm dia. threaded at the upper end. Extension rods consisting of 2 lengths 5 cm. 2 lengths 10 cm., 1 length 30 cm.,1 length 50 cm., and 1 length 100 cm., used as spacers between the proving ring and penetration piston. The lengths are machined from steel tubing. Connector set, has eight connectors for coupling the penetration piston and proving ring assembly either directly or through extension pieces. Dial gauge support of seamless pipe construction. It stands 30 cm high and 45 cm wide at the base. Provided with a quick release screw type clamp capable of sliding and locking anywhere along 2 meter length of the bridge. Supplied with annular metal weight 5 kg., 250 mm dia with 53 mm dia central hole, Slotted metal weight 5 kg., 215 mm to 250 mm dia with 53 mm dia slot, 2 Nos. Slotted metal weights, 10 kg., 215 mm to 250 mm dia with 53 dia slot 2 Nos. Accessories : Dial guage 0.01mm x 25mm. High sensitivity Proving Ring 5000kg. capacity with calibration chart and carrying case.

• MOTOR SPEED: 0 TO 1500 RPM (APPROX)
• EQUIPMENT WEIGHT: APPROX. 2KG
• TPI RANGE: 1 COUNT FOR TPM/0.250 COUNT FOR TPI

Clamp the yarn in the clamp fixed on the motor shaft. A guide is provided on the clamp for easy clamping. Pull the other end of yarn through the clamp on the moving crosshead had while clamping ensure that yarn is clamped for proper test length and yarn is free and under correct tension of weight. This is necessary to have uniform length of yarn between the clams under fixed tension to get proper repeatability of the results. Select SZ switch in S or Z position depending upon type of yarn. Put the main switch ON and press the ‘RESET’ push button to ensure zero reading on the digital display unit. Select the motor speed to high speed position. Select ‘NORMAL’ position for initial operation. Start the motor using ‘START STOP’ switch. The motor will now start untwisting the yarn and DIGITAL DISPLAY will start counting. After reaching approx. 90% of expected TPM reading, it is recommended to lower the motor speed to minimum possible to get better results. By using ‘ADJ knob’ the motor can be run in very slow to moderate slow speed, or if motor stops completely test can be run manually by pushing motor shaft by hand.The instrument carries a guarantee for 12 month for free repairs against any manufacturing defects. However this guarantee is void in case of any physical damage or attempted repairs at customer’s end. The instrument is required to be sent to our works at customer’s expenses for claiming warranty services.

Automatic Twist Tester, IR Beaker Dyeing Machine, button snap pull tester

Sand Absorption Cone and Tamper, Vibrating table, Phosphate Rock

Liquid Limit Device, Compression Testing Machine, Electronic Total Station