Chemical Evaporators Dealers

• Type: Chemical Evaporators
• Material: Aluminum, Stainless Steel, Titanium
• Application: Chemical Industry, Food Industry, Pharmaceutical Industry, Water Treatment Industry
• Color: Black, Blue, Green, Red, Silver
• Voltage: 110V, 220V, 380V, 440V, 580V
• Condition: New, Used
• Finishing: Non Polished, Polished
• Automatic Grade: Fully Automatic, Semi Automatic
• Feature: Easy To Use, Ergonomic Design, High Grade Material, High Working Efficiency, Longer Service Life, Simple Operation
• Phase: Double Phase, Single Phase, Tripple Phase
• Steam Pressure: 0.5Mpa, 0.6Mpa, 0.7Mpa, 0.8Mpa
• Evaporation Capacity: 0-1000lts/h, 1000-2000lts/h, 10000-11000lts/h, 11000-12000lts/h, 12000-13000lts/h, 13000-14000lts/h, 14000-15000lts/h, 15000-16000lts/h, 2000-3000lts/h, 3000-4000lts/h, 4000-5000lts/h, 5000-6000lts/h, 6000-7000lts/h, 7000-8000lts/h, 8000-9000lts/h, 9000-1

Evaporator is used for converting the liquid form of a chemical into its gaseous form. This technique of evaporator is utilized in making the concentration of food and chemicals. Evaporators are mainly used in food and beverage industries as in these products certain amount of uniformity in evaporating is needed. If there will be regular removal of moisture in the apparatus through vaporization in that case amount of wastage can be easily controlled. The main thing that separate this method from other means of evaporation is only the final concentrated product which is extorted at the end of the procedure. There are many types of evaporator system that usually used in our day to day lives likes natural circulation evaporator, multi-effect evaporators, falling film evaporator, etc. A good amount of heat is needed in the system to separate the molecules of the solvent which later moved to air nearby the solution. During designing an equipment this thing must be concerned that there should be a balance in the amount of energy that will lose during the process near the surroundings. Rufouz Hitek Engineers are the peak most evaporator manufacturers and offer more effective and uncomplicated approach to meet your all types of requirements. Our prepared evaporator design is able to handle a broad range of industrial procedures related to the evaporating.

Chemical evaporators This evaporator comes with a temperature switch to optimally control the distilling processes.Automatic cut off system to avoid over heating.

Chemical evaporators are becoming extremely conscious about the water usage of industry with water tables going down & quality of ground deteriorating, the companies are being forced to comply with norms of “Zero Liquid Discharge”.This means that the industry not only has to ensure treatment of the effluents being generated by them, but are also responsible to extract reusable water from it to the extent that they generate solid waste as final reject & permeate water as main product.

Are used wherever the rate of unaided chlorine gas withdrawal from multiple containers is not fast enough to keep up with consumption requirement. The main function of the evaporator is to convert liquid chlorine into gas chlorine form.It is an electrically heated immerse tank type heat exchanger. The unit has adequate controls & safety function for operation. Level in the water bath tank is maintained by solenoid which controls make up water flow. The thermostat maintains hot water temperature. The evaporating chamber and water tank are cathodicaly protected. The electric water heater is immersed in to water bath tank assuring uniform distribution of heat. The Evaporators are available in various capacity ranges considering rate of withdrawal of gas.

The Evaporators that we offer is segregated into two cubicles; the Inner Cubicle and the Outer Cubicle. Chlorine liquid is shifted directly from the source to the inner cubicle through the container pressure. The Inner Cubicle is immersed in a temperature regulated steam bath that enhances the temperature of chlorine making it to boil and vaporize. The Chlorine liquid enters the inner cubicle and keeps the needed level required to meet the vaporization rate for gas demand. Automatically, a shift in gas demand will make the chlorine liquid level to adjust. The gas thus produced is superheated as it travels through series of baffles while leaving the cubicle. Normally, a superheated gas is needed to check the re-liquefaction of chlorine in the process lines.

  Our company also manufactures a range of dryers for different We manufacture high performance evaporators to cater to various industrial needs. Evaporators are available with different specifications. The different types of evaporators available for varied applications are rising film, folling film, thin film, and forced circulation type.

Chlorine is used in various industries for diversified applications. Chlorine is generally stored in liquid form in Ton containers or Cylinders. Generally, Chlorine gas withdrawal rates from these containers do not exceed the vaporization rate (normally it is 7 to 11 kgshr at around 28 deg Celsius ). Evaporators are used where large quantity of chlorine gas is required.

• Automatic Grade: Automatic
• Application: Chemical evaporation
• Max Temperature: High

• Material: SS316
• Phase: 3 phase
• Country of Origin: Made in India
• Capacity: 10 KLPD
• Automation Grade: Semi-Automatic
• Max Temperature: 200 Deg C
• Frequency: 50 hz

• Material: MS
• Automation Grade: Semi-Automatic
• Max Temperature: 60 to 80 deg C
• Usage/Application: Industrial
• Design: Customized
• Power: Electric

STEAM HEATED CHLORINE EVAPORATOR, Gas Chlorination System

chlorine evaporator, conveying equipments, chlorinated paraffin wax plant

chlorine gas evaporator

chlorine evaporator

Chemical Evaporators, spin flash dryers, Pilot Plant

Chemical Evaporators, Chemical Mixing Equipment, Chemical Transfer Pump

Semi Automatic Chemical Evaporators, Design Services

Chemical Evaporators, Secondary Combustion Chamber, GMP Grade Reactor