Fire Retardant Paints Dealers

We provide one of the best Fire Retardant Paints for your buildings. With its additional protective layers, the paint swells at high temperatures to provide thermal insulation by creating a porous layer on the metal and between the surfaces. This does not have any odour and is eco-friendly and explosion safe. This provides more than 25 years of protection and is available with us at affordableprices.Titan: Which can be used as a fire retardant coating for all steel structures & concrete interior areas not exposed to weathering & fully preserves the configuration of the treated surface. Description:"Titan" fire-retardant paint is a suspension of heat-resistant, gasforming, foaming additives with inorganic fillers in the dispersion ofPolyacrylates : The paint swells at high temperature to form a thermal insulationporous layer on the metal and beton surfaces. Coating based on fire-retardant paint Titan" with an additional protectivedecorativesurface layer: Thermal insulating porous layer formedafter swelling of the coatings based on fire retardant paint "Titan" after fire exposure. Titan can be used as a Fire retardant coating for all surfaces of Steel structures and Concrete in interior Areas without exposure to weathering.Fire-retardant paint "Titan" is used for the flame-retardant treatment of steel and beton primed structures. Up to 120 minutes fire resistance operating in interior (up to 150 minutes for beton surfaces). For fire protection of steel structures outside on surfaces not exposed to direct rainfall, "Titan" is used with an additional protective and decorative surface finishing. Fully preserves the configuration of the treated surface. Eco clean, non-toxic, fire and explosion safe. No sharp odor. More than 25 years of fire protection.Fire-retardant paint "TITAN" meets the requirements of the Technical Regulations on fire safety requirements (Federal Law of 22.07.2008 â�� 123-FZ), GOST 53295-2009 "Means of fire protection for steel structures."The coating is applied on primed steel structures (columns, beams, overlaps, connections, etc.). Check the condition and quality of previously applied anticorrosion coating, the time of its application. If necessary, repair the corrosion-resistant coating. Use the same materialat the repair (glyptal based anticorrosive primers are recommended) Ambient temperature - min +5 ° C; Relative humidity - 85%; The treated surface temperature should be above the dew point of not less than 3 ° C. The application of paint performed by mechanical means, using airless aggregatesspraying high pressure plunger pump (type «WAGNER HC 960E»), or manually (brush orroller).The paint is thoroughly mixed with an electric mixer for 3 – 5 minutes before applying Fire-retardant paint is applied in layers, in several passes. Depending on the method ofapplication a layer thickness of the dried coating may be 100-400 microns.It's recommended to apply paint wet film of 400-600 microns thickness in one pass.Recoating is carried out after 2-6 hours (depending on the application conditions).Final drying: 1 - 4 days. Coating based on the fire-retardant paint "Titan" can be operated in therange of temperatures from – 60 °C to +60 °C at the relative humidity of 85%.In case if relative humidity is more 85% , the use of additional protective anddecorative surface layer must be applied in accordance with the "Technologicalinstruction # 001-I-U / 8 on application and exploitation of fire retardant paint "Titan".Packing: plastic or metal pails of 25 kg.Transportation: at temperature above 0 °C.Shelf life: in the manufacturer's packaging in a dry place at a temperature above 5 °C –12 months.

• Type: Paint
• State: Liquid
• Application: Use by Brush
• Color: Available in Many Colors
• Warranty: 2 Years
• Quality: Good

Buyers can stay rest assured with us for their orders as we ensure zero damage to the products that we deliver. For this, we store the entire lot in a spacious warehouse till the final dispatch. We can be entrusted for delivering the orders within the promised time frame as we have sophisticated transportation facilities. We make available, Solvent Based Fire Retardant Paint, which is highly appreciated for its unique resistant capacity.  

Glo-Protek Intumescent Coatingis an intumescent fire-retardant paint that not only retards the spread of fire, it also insulates the substrate from the intense heat of a fire. This coating dries quickly to a flat matt finish having the appearance of conventional matt finish paint. On contact with fire or excessive heat, the paint puffs up (intumesces), forming a thick, spongelike cellular foam layer over 100 times thicker than the original paint film. This foam layer insulates the substrate from the heat of the flame, thus retarding flame spread and minimising delaying structural failure.

• Packaging Size: 5 L
• Paint Base Type: Solvent Based
• Form Of Paint: Liquid
• Features: Heat Resistant
• Packaging Type: Can

• Country of Origin: India
• Brand Name: Feukem India Pvt. Ltd.
• Application: MS, GSS, Steel,Wood

Only quality packaging material has been used for the packing of the products that we offer. Moreover, the entire packaging procedure is conducted under the supervision of the experts. We are a noteworthy name, engaged in offering qualitative lot of products that are the perfect outcome of premium material and modern work methods. Also, the material is sourced from the trusted places after complete quality checking.   We provide fire rating for this product. Government of india lab tested and approved product : Fire retardant solvent base paint is specially prepared for metal surfaces and for interior use. This product is certified by national test house of government of india for 2 hour fire rating. Steel structure and frames or sheets are generally coated with this coating. Since this is alkyd base coating, it is of low cost as compared with epoxy base coatings. As steel structure does not catch fire but transfers heat from one region to other, the fire ignition chances in other area Increases thereby flame spread starts. But after application of these coatings, heat transfer is blocked for the time specified with dft (dry film thickness). Also inert gasses released block oxygen supply to area under fire. Hence these are very useful interior coatings. prepare the surface with shot blasting. Apply ugam f r primer for steel, single coat. Apply ugamcoat141098 to the desired thickness depending on fire rating required. Allow minimum 5 hours in between coats to allow curing. Finally apply two coats of ugam f r topcoat to protect the fire retardant coating from moisture. It can be tinted by universal stainer. Once exposed to fire, the surface should be repainted. This system also come in epoxy base type for exterior exposed surfaces of steel. Specifications : Product - ugamcoat 141098. Type -  fire retardant paint. details of tests passed. Ugamcoat 141098 passes the test safe`s following tests : Flammability testing of materials and substances, combustion. Product analysis with heat, toxicity and smoke yield. Explosibility testing of materials, including flammable gasses, dusts, and vapours. It also passes bench scale flammability test. Ugamcoat 141098 passes the nfpa 703 test for fire retardant impregnated wood and fire retardant coating for building materials. Product Details: Minimum Order Quantity - 10 Litres Packaging Size - 10 L State Of Matter - Liquid Type of Surface Paint - Unpainted Types Of Surface - Metal

• Type: Paint, Intumescent coating
• Certification: CBRI, UL 1479, IS
• Application: Brush, Roller, Spray Gun
• Color: Multicolor
• State: Aerosol, Liquid, Paste
• Packaging Type: Can, Bucket
• Finish: Mild Sheen
• Packaging Size: 1-5 L, 15-20 L, 500ml
• Brand Name: Stanvac
• Country of Origin: India

• Type: Paint
• Certification: ISO9001:2008
• Application: Brush, Roller, Spray Gun
• Color: Blue, Bronze, Copper, Gold, Multicolor, Orange, Pink, White
• State: Liquid
• Packaging Type: Can
• Finish: High Gloss, High Sheen, Mild Sheen, Soft Sheen
• Packaging Size: 1-5 L, 10-15 L, 15-20 L, 20-25 L
• Brand Name: Avudai
• Country of Origin: India

• Type: READY TO USE
• Country of Origin: Made in India
• Color: White
• Packaging Size: 5KG, 20KG
• Finish: Matt
• Paint Base Type: Water Based Paint
• Form Of Paint: Liquid

We are offering fire retardants paints.

We manufacture and supply premium Fire Retardant Anti Bacterial Paint for interior and exterior applications. The Fire Retardant Anti Bacterial Paint that we supply offers anti bacterial feature and acts as an additional supplement for effective cleaning and reducing the risk of growth, spread of fungus and bacterial throughout the building. Fire Retardant Anti Bacterial Paint is widely used in hospital labs, school, food industry, washroom, lobbies etc. Cobra Brand Weathertouch – Wall finish premium quality plastic paint for interior & Exterior   Anti bacterial paint finish acts as an additional supplement to effective cleaning & reducing the risk of the growth and spread of bacteria throughout a building.   It is widely used in Hospitals, labs, schools, food industry, airports, offices, government buildings, washrooms, lobbies, and houses etc. Application Procedure Step 1 : Surface Preparation : Freshly plastered surface need no special preparation however, old surface are to be cleaned for flaking, chalking and loose plaster.       Step 2 : Sealer Coat : On old surfaces, where the plaster is weak and loose, a suitable sealer coat should be applied after priming and crack filling. Step 3 : Prime to apply cement primer coat before final application.      Step 4 : Maerial application – 2 coats Important  : For a large surface area, material of same batch is recommended  Preserve the material in a cool, dry place, long exposure to direct sunlight may change the form and condition of the material The primer & undercoat should be left overnight before application of the top coat. ] Do not apply the material in adverse climatic conditions like rain, strong wind etc. As it would affect the application. Application should be done above 25 deg. C., and on completely dry surface.

• Features: Accurate composition, Effective, Longer shelf life.

• Brand Name: Goa Paints
• Form of Paint: Liquid
• Finish: Matt
• Application method: Brush
• Packaging Size: 20 L

Fire strikeswhenleast expected.The speed at which the fire travels or propagates even a small accidental fire or electric spark caused by short circuit is sufficient to create huge, immeasurabledamageto the safety of people and properties.The fire can start fromexternal source or internal source, just from anywhere and without warning. Fire takes advantage of unprotected surfacesandareas concealed fromfire fighters. The consequences - overwhelming heat, suffocating smoke, loss of time, damage to items of sentimental value and above all, the loss of life. The insurance company may able to replace the materialgoods, but there are fewthings thatmoneysimply cannot replace.