PM10 High Volume Air Sampler
Get Price Quote
Instrumex Respirable Dust Sampler is a versatile dust sampler that is based on a design standardized by CPCB for collection of PM10 & Totoal Suspended Particulates (TSPM) in ambient air and also simultaneously samples the particulates having aerodynamic diameter less than 10 Micron. Features Simultaneous Sampling of PM10 & TSPM Brushless & Noiseless Blower Motor Programmable Timer Rugged construction for heavy duty usage Voltage Protection Relay for superior motor protection Instrument Overview Instrumex Respirable Dust Sampler employs heavy duty Brushless and Noiseless blower that draws air through a size-selective inlet and through a 20.3 X 25.4 cm (8 X 10)" filter at a flow rate, which is typically between 0.9 — 1.4 m3/min maintained by an Orifice. A cyclonic flow technique is used to separate the particles with aerodynamic diameter less than the cut-point of the inlet (PM10). These are collected by the filter. The particles greater than 10 micron are separated at the bottom of the cyclone into a dust collecting bottle. The mass of PM10 particles is determined by the difference in filter weights prior to and after sampling. The concentration of PM10 in the designated size range is calculated by dividing the weight gain of the filter by the volume of air sampled. Gaseous Sampling Normal Gaseous Sampling Kit: Aluminum enclosure housing an Ice tray attached at the back of the instrument with following provisions: Impinger stand for 4 nos. of glass impingers. 4 Way acrylic manifold with needle valves for precision flow control 0.3 - 3LP M rotameter for flow setting 4 Nos. of glass Impingers. (cap. 35m1.) Thermoelectric Gaseous Sampling Kit: In tropical weather where temperatures can soar above 35°C, the reagents in the impingers tend to evaporate quickly. This results in erroneous reporting of the Gaseous pollutants. Instrumex Thermoelectric Gaseous Sampling Kit is a separate enclosure with a Peltier cooling system that automatically maintains temperature between 10 - 15°C. Thereby completely eliminating the hassle of replacing the ice/cold water after every few hours Optional Extras Chemical Kit for sampling of SO2, NO2, NH3 & 03 Dust Sampling Bottles G FA Filter papers, Size (8x10)" Whatman EPM 2000 filter paper, Size (8x10)"
High Volume Combined Sampler Thermo TEI 450 (for PM 10, PM 2.5 & Gaseous monitoring)
Get Price Quote
Best Deals from High Volume Air Sampler
HIGH VOLUME AIR SAMPLER VHVS 5EBL
61,700 Per Set
1 Set(s) (MOQ)
High Volume Air Sampler
40,000 - 50,000 Per Piece
1 Piece(s) (MOQ)
High Volume Sampler (SSES-HVS-010) was designed and produced by Soniya Scientific Equipment Solutions Pvt. based on the concept and requirement. SSES-HVS-010 uses all over the world to measure air pollution (suspended particulate matter) in industrial areas, urban areas, on the shop floors, near monuments and other sensitive areas. By definition, suspended particulates are too small in size to have an appreciable falling velocity and are likely to remain in the atmosphere for significant periods of time. These particulates usually range from 1 micron to approximately 100 microns in size.
High Volume Air Sampler
Get Price Quote
1 pices (MOQ)
High Volume Air Sampler for PM2.5 KDM Global's line of extremely reliable and durable samplers created for capturing particulate matter and gaseous contaminants in ambient air are known as High Volume Air Samplers (HVAS). The High Volume Air Sampler (HVAS) is a piece of equipment used to sample huge amounts of ambient air in order to filter out the particulate matter it contains. Finely divided solids or liquids that are spread in the air from natural sources, industrial operations, or both are referred to as particulate matter. To stop collecting of particles larger than a certain size, a Size Selective Inlet (SSI) is used as a pre-filter. Size Selective Inlet (SSI) PM 2.5 only allows particles with an AED = 2.5 micron diameter to enter the collection medium; particles larger than 2.5 microns are not allowed. Features of the physical design: High Volume Air Samplers, such as the PEV-HVS and PEM- RDS series, PM2.5HVS, are made up of a large blower, a filter to catch suspended particles, and a way to gauge the flow rate. Through the side apertures of the SSI, suspended airborne particles are sampled at sampling rates ranging from 1.1 to 1.6 m3/min and collected on a 203 x 254 mm filter paper. Important Features: · Electronic Control Module with a Microprocessor; 32-character LCD Module with alphanumeric characters; Electronic Timer Cumulative Totalizer. · Continuous Duty Blowers; Settable Delay & Sampling Time · The exhaust orifice plate meets with USEPA standards. · An optional gaseous sampling attachment for all models. · By replacing the gable roof with SSI, it can be transformed into a PM10 sampler. Unique Characteristics: • Free flow without resistance at 1.1 to 1.7 Cu m/min flow rate. • Particle Size: Depending on the filter being used, down to 0.3 micron. Filter holder made to fit any standard 8" X 10" (20.3 X 25.4 cm) size filter sheet. • The GF/A filter is advised for general use, and EPM 2000 for specialised research. • Time Totalizer: Record the running time in hours from 0 to 99999.99 hours for sampling time: • Automatic Sampling: A 24 hour programmable timer that automatically turns the device on or off after the preset intervals can be easily set. • 220 volts, 5 amps, single phase AC power requirements. Rotameter flow rate is measured with a plastic body flow metre with a 2% FSD accuracy between 0 and 3 lpm.
0.0
View Profile
High Volume Air Sampler
31,000 Per Piece
1 Pack(s) (MOQ)
application: technogroovy's high-volume device is an essential device primarily used to measure the concentration of suspended particles in air. By definition, the suspended particles are very small, have a noticeable rate of decline, and are likely to remain in the atmosphere for significant periods of time. The size of these particles usually ranges from approximately 1 to 100 μm. the total suspended particulate sampler or the tsp large volume air sampler is used to collect the total suspended particulate matter in the surrounding air, where size selection is not preferred. Epa reference method. United states of america for the tsp group. technogroovy's high-volume air sampling collects particles at a flow rate of 40-60 feet during a continuous sampling period. The tsp oversized air sample is used to determine the total suspended particle concentration or can be used to determine the particle identity. technogroov's oversized air samples come in a variety of configurations. The platform consists of an anodized aluminum exterior shelter with a flexible roof group. This will include a timer for turning the instrument on and off, a filter holder for the filter media nodes, a vacuum drive, a flow control device, a pressure logger for recording the flow, and the elapsed time indicator for the time calculation. A sample. specification: • flow rate 1.1to 1.7 cu m/min • particle size down to 1.6 micron depending upon filter used. • recommended filter : gf/a (8” x 10” ) for common use and epm 2000 for special research use. • sampling time record : 0 to 99999.99 hrs. Time totalizer records the running time in hours. • automatic sampling : 24 hour programmable timer, required intervals can be conveniently programmed. • power requirement : 220 volts, 2 amps, single phase ac. • size : with gable roof 440mm (l) x 440mm (w) x 820mm (h) • weight : 25 kg
0.0
View Profile
High Volume Air Sampler
Get Price Quote
5 Piece (MOQ)
High Volume Air Sampler
Get Price Quote
1 Set (MOQ)
0.0
View Profile
High Volume Air Sampler
56,000 - 57,000 Per Piece
0.0
View Profile
High Volume Air Sampler
Get Price Quote
Yash High Volume Air sampler for the monitoring of suspended particulate matters, and gaseous pollutants like SO2, NOx etc. With inbuilt stabiliser, timer, time totaliser including gaseous assembly for gaseous measurement etc.
0.0
View Profile
High Volume Air Sampler
Get Price Quote
We manufacture, export, and supply a supreme range of High Volume Air Sampler across the globe. The quality tested High Volume Air Sampler provided by us conform to guidelines of Central Pollution Control Board. It is used to monitor the air to determine the extent of pollution and to identify the source of emission at regular interval of time.
0.0
View Profile
High Volume Air Sampler
Get Price Quote
he high volume air sampler collects suspended particulates on large filter paper The name high volume is appropriate because the sampling flow rate has a high level of 20 to 60 standard cubic feet per minute (SCFM). Because of the high flow rate, large quantities of particles ranging from 0.1 to 1 gram are collected over a typical 24-hour sampling period Characteristics: Brushless Blower, Low running cost, Low noise operation, Controlled flow, Light weight and small in size, Drain plug for manometer.
0.0
View Profile
High Volume Air Sampler
35,000 Per Piece
1 Piece (MOQ)
0.0
View Profile
High Volume Air Sampler
45,000 Per Piece
0.0
View Profile
High Volume Air Sampler, Dust-Dioxin
Get Price Quote
High Volume Air Sampler, Dust-Dioxin, Xenon Test Chamber
0.0
View Profile
High Volume Air Sampler
Get Price Quote
High Volume Air Sampler, Respirable Dust Sampler, Air Monitoring Instruments
0.0
View Profile
High Volume Air Sampler
Get Price Quote
High Volume Air Sampler, Continuous Emission Monitoring System
0.0
View Profile
High Volume Air Sampler
Get Price Quote
High Volume Air Sampler, Combo Dust Sampler, Respirable Dust Sampler
0.0
View Profile
Digital High-Volume Air Sampler
Get Price Quote
Digital High-Volume Air Sampler, Universal Calibrator, Spectrometers
0.0
View Profile
High Volume Air Samplers
Get Price Quote
High Volume Air Samplers, Ambient Monitors
0.0
View Profile
Post Free Ad
