Kemi Vineers Perumbavoor, Ernakulam, Kerala

Made with heavy gauge MS tubular pipe with thick gauge MS frame duly powder coated OR Tubular Aluminium Pipe with Aluminum frame having rack size of 48'' X 21''. Height between each rack is 15''. Each rack is fitted with two nos of fluorescent tube and one U.V Germicidal tube. Each tube has separate ONOFF switch. 0-24 hours weekly Cyclic Timer also equipped with the unit for illumination purpose [for controlling all the fluorescent tubes inside the racks]. Electronic chokes are fitted on a separate side control panel box. Complete with 15 Amps cord wire plug to work on 230 VAC.

These shakers are ideal for mixing and development of cultures, chemicals and pathological work etc.The unit is fabricating from heavy mild steel duly powder coated with continuous duty motor and controllable shaking speed upto 250RPM having different sizes of platforms with rubber disks for holding flasks.

Double wall, inside made of S.S and outside of M.S duly powder coated with a Temperature range ambient + 5°C to 80°C, Temp is controlled by Micro Processor based Digital Temperature Controller Cum Indicator [LED]with an accuracy of+-0.5°C and with shaking speed of oscillating tray is 40 to 140RPM. Supplied with SS tray having Lotus Clamps. Driven by geared motor and supplied without thermometer.

Low priced units meeting the majority of the small capacity centrifuging requirements of medical practitioners, pathological laboratories and Hospitals for routine centrifuging tests. The units are fitted with resiliently mounted motor for vibration free performance having built-in 5 step speed regulator. Available with Swing out and Angle Rotor Heads.

-Laminar Flow principle involves double filtration of air. Atmospheric air is drawn through pre-filter and is made to pass through highly effective HEPA (High Efficiency particular Air)deep pleat filter having efficiency rating as high as 99.99% with cold DOP and 99.97% with hot DOP, thus retaining all air-borne particles of size 0.3 micron and larger. Double filtered air blows in laminar flow through the worktable at designed velocity of 90 ftmin +-20%. Noise level: - Less than 65 db at work area, and Vibration:-0. 00005 cm of work table.

  These platelet Incubators are specially designed for close environment control for stored platelets. Ideally suitable for accommodating KEMI Platelet Agitator.  Temperature range can be adjusted from 5 0C to 60 0C. Constructed of double walls, the exterior is made of mild steel duly powder coated and the inner chamber is made of SS.   The plexy glass inner door make its possible to inspect without disturbing the temperature.  All controls are mounted at the bottom of Platelet Incubator. Model No.Inner Size L x B x H (mm)Capacity KPI-1 480 x 380 x580 110 Ltr   Optionals 1. Recorder -7 days Circular chart Recorder - Ink type and Inkless type (Thermal Chart Paper)2. Automatic Voltage Stabilizer 1 Kva NB: Non-use of stabilizer will render the warranty of the equipment invalid.

  It is specially designed to maintain donor platelets in an even suspension throughout blood plasma. Platelet Agitator agitates at a fixed speed of 70-80 strokes per minute.  Maximum 32 standard blood bags can be accommodated.

  Made of outer MS sheet duly powder coated and inner made of SS sheet .The temp is maintained by a programmable micro processor controller, temp range + 37°C to 56°C, +/-0.5°C with audio visual alarm for low & high temp. Mechanism of thawing is by pumping with high capacity pump and maintain temp of water by heater with sealed sensor dipped directly in water. Removable type S.S tray with partition for holding 12 bags. Foldable lid with outer S.S and inner plastic with two handles. The whole unit is to work on 230V, 50Hz.   Model No.Inner SizeCapacityCap of Plasma bag KPTB-1 470x290x260mm 40Ltr 12-15   Stabilizer can be supplied at an extra cost on request. NB: Non-use of stabilizer will render the warranty of the equipment invalid.

It is an eco friendly CFC free refrigerant and specially designed for storing blood bags and other specific medical products like vaccines, cultures, reagents, etc., in fixed temperature of 4 0C to 6 0C with an accuracy of +/- 1 0C. Made of double walled -Inner chamber stainless steel and outer mild steel beautifully powder coated. Temperature Controller : Fully Automatic Micro Processor Controller  Refrigeration: By hermetically sealed compressor unit with capillary controlled balanced system  Insulation :PUF Illumination :Internal cabinet lighting is provided with CFL, whenever the door is opened  Doors: 1. Full view inner acrylic glass door                                   2. Outer door is provided with magnetic gasket, which keeps the door sealed against                                              warm air and moisture   Storage:  Provided SS trays for storing standard Blood Bags  Safety: An audio visual alarm which comes into operation in case temperature variation beyond limit, either power failure or any other reason there by protecting the precious samples stored inside Optionals 1. Recorder -7 days Circular chart Recorder - Ink type and Inkless type2. Micro Processor Temperature controller to take print out of the temp reading in regular intervals.3. Automatic Voltage Stabilizer 1 Kva [For KBR- 40& 70]    Automatic Voltage Stabilizer 3 Kva [For KBR - 120&144] Note: Outer body SS 304 quality can be fabricated on extra cost.  

  Oscillating platform is made up of SS, been oscillated up and down with approximate 30 mm displacement at the end.

  Most versatile for Biochemical Oxygen Demand determinations.  These Cooling Incubators are designed specially for close control of incubation /storage temperatures.  These are used for BOD test, storage of sensitive cultures, vaccines etc; culture of bacteria microorganism and plant life; serum incubation studies and immunological work etc.  There is provided illumination inside the working chamber with the help of CFL.Double wall construction, inner made of Alu/SS and outer M.S beautifully powder coated with adjustable trays.  The instrument is having CFC free refrigeration and heating system with powerful Air circulation for creating positive airflow throughout the working chamber. The unit having a temperature range from 5 0C to 60 0C with an accuracy of +/- 0.5 0C. Kemi Make Micro Processor Digital Temperature Controller cum Indicator controls temperature.   Optionals 1. Chamber illumination with the help of Fluorescent Lamp2. Sterilization of work area with the help of UV Lamp3. Cyclic Timer 0-24 hours for regulating illumination4. Automatic Voltage Stabilizer 1 Kva [For KBOD- 3& 6]5. Automatic Voltage Stabilizer 3 Kva [For KBOD - 12&10] Note: Full Stainless Steel unit can be supplied in all models at on specific order.NB: Non use of stabilizer will render the warranty of the equipment invalid.

Double wall construction, inside of AluS.S and outside of M.S beautifully powder coated with a front door having glass window to inspect the samples inside the chamber. These chambers are designed for environmental testing of production samples where both temperature and humidity are to be controlled. Temperature can be controlled from 5°C to 60°C with an accuracy of +- 1°C. Temperature and Humidity controlled by Digital Temperature Controller Cum Indicator-LED [Dry & Wet Bulb Method] from 40% to 95% with sensitivity of +-3%. Supplied with relative Humidity Chart but without hygrometer. Power supply -220230 V.

The technical features are same as Horizontal Laminar Air Flow Cabinet but the air flow passing through the Hepa filter (Deep Pleat)"CLASS 100" [with the help of 15HP motor-1440Rpm] in vertical way and the contaminated air is going through the exhaust duct [14 HP motor-2880 RPM] fitted on the back bottom of the unit. The instrument is made of marine plywood with exterior epoxy water and chemical proof painted with putty finishmica.

It is table top front loading autoclave, double walled out, outer M.S powder coated inner 30 grade S.S. All joints are argon welded. Door is amde up of heavy gauge S.S shet and using high quality silicon gasket used with ISI marked immersion heater 1.5 KW in 230240V Features: Fully automatic microprocessor based control. Digital timer both for wet and dry cycle. Alarm after the total command is completed. Cyclic timer 10 to 15 minutes. Temp range 121oC - 134oC Unit is supplies with 2 Nos. S.S trays with tray stand.

This vortex mixer is used for thorough mixing of precipitates in test tubes, small bottles or flasks. A speed regulator switch also provided to control the speed. Suitable to work on 220VAC