Drill Rods Dealers in Faridabad

• Country of Origin: India
• Type: Drill Rods
• Material: Mild Steel
• Shape: Round
• Usage/Application: Industrial
• Technique: Hot Rolled
• Hardness: 50 HRC
• Thickness: 17mm

Another variable which determines the ultimate success of the electrode properly EDM Hole Burning through the material or work piece is if the Brass Electrode or Copper Electrode tube has a “single hole” or a “multi channelled hole” running directly through the ID or (Internal Diameter) of the electrode. Basically put; in order for an electrode to perform the way it’s supposed to, it depends on the type of hole going through the centre of the electrode. This type of hole has a few purposes. One purpose is to direct water or coolant through the centre of the electrode. This keeps the entire length of the Brass or Copper Tube from overheating and burning up. If the electrode heats up too much it can become “soft” and warp thus not creating a straight line or a consistent and accurate EDM Hole. The main reason that determines whether an EDM Electrode tube would have a “single hole” or a “multi-channel” “coreless” hole is that when a hole is EDM Machined into a part it could be a “thru hole” or a “blind hole”. Blind holes are not drilled complete to the other side so a “slug” or a piece of material is still left untouched at the bottom of the hole.

These centralizers are designed to give a minimum amount of drag resistance when passing through the previous casing or wellhead and then spring out to fit undreamed sections and washouts. Used for oversized holes The welded construction provides for superior strength over non-welded centralizers. High quality springs steel undergo consistency special heat treatment. Hinge installed around the casing O.D. Runs freely into difficult well-bores while providing excellent standoff. Available Size: 4-1/2 to 7. (Any special sizes or combination can available on request).  

coal drill rods, Auto Parts, Clutch, Gear Box, Cutting Tools

Drill Rod, Tractor Parts