Industrial Heaters Dealers in Karkhana Bagh, Faridabad

We are offering induction bar heater. Stead fast engineers is a pioneer in manufacturing world class induction heating machines under the brand name ‘stefen’. Stefen induction heating machines are sophisticated yet user friendly. Using state of the art technology these machines are designed to increase the customer’s profitability and improve his market credibility by minimizing down time. Following are the benefits of stefen induction heating machines.

Stead fast Engineers is a pioneer in manufacturing world class Induction heating machines under the brand name ‘STEFEN’. STEFEN induction heating machines are sophisticated yet user friendly. Using state of the art technology these machines are designed to increase the customer’s profitability and improve his market credibility by minimizing down time. Following are the benefits of STEFEN induction heating machines.     Series Inverter Design Power factor above 0.98 at all Loads Single Digital module in entire power supply Digital module with 5 years warranty Capacity 50 KW to 1200 KW Maximum guaranteed output efficiency No Breakdowns Automatic Temperature Control Automatic frequency control Rugged Construction

Committed to excellence-Increase performance-Drive Innovation-Act responsively -Value People-Attract and empower talent-Customer focused Non-siliconized or low-siliconized semi-finished strip is increasingly used for the manufacture of magnetic cores for electrical equipment. The cores are fabricated from cold rolled strip which undergoes critical deformation after recrystalization and must be annealed after punching. Following annealing, core loss is of an order of 2 to 4 W/kg for a sheet thickness of 0.5 to 0.7mm. Electrical sheet manufactured by this process is superior to dynamo strip not only with regard to cost but also with regard to: saturation  A.C. premeability  core loss (due to magnetic transformation)  ageing  lamination factor and  the quality of the cutting edges   Appropriate temperature and furnace atmosphere control induces three simultaneous heat-treatment effects needed to fabricate material of the properties required. The hard, fine-grained ferritic structure is transformed into a soft coarse-grained structure according to ASTM series 2½ to 3½. At the same time, the carbon content of the metal is reduced to less than 0.005% to prevent any effect of residual carbon on the properties of the material ageing. Further, an oxide coating is obtained at a temperature of 550°C. Decarburization and plating necessitate permanent contact between the reaction gas and the strip surface. The oil, normally applied prior to punching the laminations, is burnt off in the first heating zone.

electric immersion heater, Exhaust Fan, Turbo Domestic Exhaust Fan

Solar Water Heater, Solar Dryers, solar cooker & wind generators