Back Back
U Type Special Mould Clamp
Get Price Quote
For Plastic Injection Moulding & Pressure Die Casting Machines It is one of the conventional type clamping system made up of S.G.I steel in 500/7 grade. Used in clamping of heavy moulds on plastic injection moulding machines and pressure die casting machines. It comes with forged stopper bolt for the height adjustment and special washer at top of clamp to move the bolt in slot at desired portion. It is used to clamp different sizes of moulds on same machine through it height adjustment feature. It helps save the time of the operator while changing the mould on machine therefore increase the productivity.
MOULD CLAMP - FORGED
Get Price Quote
The Popular 'TOOLFAST' mould clamp is now available in forged steel body for exira strength. All models shown below are similar to the MC models on the previous page.
Best Deals from Mold Clamps
Mould Clamp
Get Price Quote
Our Mould Clamp is designed for Plastic Injection Moulding & Pressure Die Casting Machines to clamp the mould with adjustable half round washer and stud and flanged nut. Our Mould Clamp is made from S.G.I cast iron with 600/3 Grade. Today, we are counted among the key Plastic Injection Mould Clamp Manufacturers in India.
Mould Clamp With Clamping Stud & Flanged Nut
Get Price Quote
Features/uses Useful for clamping of moulds on plastic injection moulding machines and pressure die casting machines. Special u—type (open ended) strap clamps having threaded adjustable support at the rear which can be adjusted to required height (as per mould plate thickness). Front portion ofthe clamp holds the mould. Very convenient for operator as there are no loose parts which tend to fall down during setting hence saves setting time. Specially designed washer distributes the load and holds the clamp. Supplied complete with Studs/T-bolts / Special washer! Flanged Nut
mold clamps
Get Price Quote
Mold clamps, The positioning of forged swival washer on required curved groove enables the operator to set the center distance between the clamping portion and the clamping bolt as per the nearest tapped hole available on platen (where there are noT-slots). No supports are required at the rear of the clamp as the rear portion rests on the platen and front holds the mould. Flanged nut is tightened on the swival washer which takes care of the positioning of clamp body. These clamps are equally useful on pressure die casting machines, hydraulic presses & power presses where low height clamping is done.
Mould Clamps
Get Price Quote
Mould Clamps, Hydraulic Pallet Truck, strap clamps, Studs, T Bolt
