EFFIMAC EQUIPMENT PVT. LTD. GT Road Industrial Area, Ghaziabad, Uttar Pradesh

The Tube Mill is a combination of equipment installed in a line for the production of High Frequency Induction Welded (HFIW) carbon steel tubes. The process involved is cold forming of carbon steel strip in circular shape, longitudinal welding, sizing, converting into RectangularSquare shape and cutting to pre determined length.

Slitter takes the strip further but now in slitted condition. All the slits are taken forward over the roller table & loop table, through line separator, pressure pad & deflector roll in to the Recoiler drum where the ends are inserted in the gripping slot. The ends are properly positioned in the slot as per the setting of Over Arm Separator and the drum is expanded.

The Pipe Mill is a combination of equipment installed in a line for the production of High Frequency Induction Welded (HFIW) carbon steel tubes. The process involved is cold forming of carbon steel strip in circular shape, longitudinal welding, sizing, converting into Rectangular Square shape and cutting to pre determined length.

The uncoiler drive rotates the coil and brings the leading end in the feeding position. Snubber roll in lowered on the coil and the coil straps are cut. With the operation of peeler table & uncoiler drive, the leading end is fed in the Pinch Roll leveler. The rolls are pressed and the drives of uncoiler & pinch roll take the leading end forward though loop table , vertical guides, measuring roll in to the feed roll. As the Feed roll motor accepts the leading end, the loop table is removed back and the pinch roll drive takes the material in the loop. The leading end is taken ahead of the shear and the end is cut.

The uncoiler drive rotates the coil and brings the leading end in the feeding position. Snubber roll in lowered on the coil and the coil straps are cut. With the operation of peeler table & uncoiler drive, the leading end is fed in the Pinch Roll leveler. The rolls are pressed and the drives of uncoiler & pinch roll take the leading end forward though loop table , vertical guides, measuring roll in to the feed roll. As the Feed roll motor accepts the leading end, the loop table is removed back and the pinch roll drive takes the material in the loop. The leading end is taken ahead of the shear and the end is cut.

CR coil is loaded on the Coil Car by overhead crane. The coil car travels on rail lines by AC motor & brings the coil to the uncoiler. The lifting cylinder of the coil car centralizes the coil to the Uncoiler centre. The two opposed bodies of the uncoiler are mover towards each other so that the collapsed drums of both the bodies enter the ID of the coil. After proper positioning, the drums are expanded to hold the coil firmly. The coil car is lowered and taken back.

Type : Automatic Steel Coil Slitting Line Machines

Material : Stainless Steel

Certification : ISO-9001:2008 Certfied

Condition : New