Pliers Dealers in Bulandshahr Road Industrial Area, Ghaziabad

LOCATION The Disc & Drum Shear is placed between the Roughing and intermediate Mill. APPLICATION To Cut the front and back end of the squares upto 32 mm at 900o C In case of misroll at the Intermediate or Finishing Mill the deviator pipe is shifted directing the bar to the Drum Shear which cuts It into scrap pieces ADVANTAGES In the mills the Snap Shears are mounted on repeaters to cut the bar in case of misroll, but the bar which is coming from the Roughing Mill is continuously fed into the mill is getting entangled on the roll. This feeding of the bar is stopped by cutting at the Drum Shear, thereby drastically reducing the down time of the mill in case of misroll. FEATURES Both Disc & Drum Shear are with case carburised, hardened & ground gears, (almost eliminating teeth wear) with near zero backlash. The cut pieces at the Drum Shear are collected in a tray placed under the silo, keeping the surrounding clear and enabling easy removal

The least expensive and simplest device for producing heavyweight bundles is the riding stripper. When the stripper is full, it is removed from the Wire Drawing Machines and collapsed over the center of a wire carrier onto which the wire drops. The Stripper is then reinserted into the finishing block and the cycle repeated. The figure illustrates such a stripper without wire. 

Used In Pairs Between Roughing And Intermediate Finishing Stands To Crop Front And Back Ends In Strip TMT Bar/Wire Rod Mills. Special Feature Frame Fabricated With Stress Delivered Structural Sheets Flats. Drive Gear Box Fabricated Of Steel Plate Body Is Provided With Oil Lubrication System. Shearing Blades Of H.C.H. Cr. Steel/Tank Plate Or EN39-B En-8 Forged Shaft Mounted To Roller Bearings Gear Box Connected To Electrical Drive Through V-Belt And Pulley Pneumatic Cylinder Of Adequate Capacity Controls Shearing And Swiveling Operation Of Shears Blades.

Flying Shears, Rolling Mills, tmt equipments, Steel Rolling Mills