Medisef Basharatpur, Gorakhpur, Uttar Pradesh

biological safety cabinet class ii "medisef" biological safety cabinet class ii is an open-front, airy cabinet. this cabinet provides a hepa / ulpa-filtered, reactivated mass airflow within the work area. the exhaust air from the cabinet is also filtered by the hepa / ulpa filter. the class ii will provide biological safety cabinet personnel, environment and product protection. while hepa / ulpa filters are effective to trap particulate and infectious agents, these filters will not capture volatile chemicals or gases. in the microbiological laboratory, using a biological safety cabinet class-ii provides additional potential and additional capacity and benefits of protecting the contents contained within it from the extrajudicial contaminants. this capability is provided by hepa-filtered, re-circulated mass airflow within the workbench. it is suitable for the inclusion of biological hazardous materials and, unlike class i biodiversity cabinet, it is also suitable for cell cultures as a sterile environment.   special features: ø  reduced cost. ø  slow voice. ø  user friendly ergonomic design ø  controlled environmental bias free product protection. ø  the work area is surrounded by negative security, double wall planners for safety. ø  aerodynamic designed airflow grills protect the block by blockage. ø  mute vibration ø  free blower ensure uninterrupted operation. ø  sound level no more than 65 dba. ø  the unit is suitable for class 100 position. ø  70% of the air is circulated again through the hepa filter. ø  the contaminated air is pulled by the blower through the plenum of the cabinet. ø  30% air exhausted from the work area. ø  filtered exhaust - protects the ambient environment, and avoids particles produced in the air. ø  the exit of the safety cabinet is linked to the virus burnout unit to protect the product and personnel. ø  the air is pulled through the pre-filter and it is made to pass through the high effective hepa (high efficiency special air) filter. ø  the efficiency of the hepa filter is more than 99.97% below 0.3 microns. ø  original material of thick board wood front back top and outer surfaces are covered with formica. or cold rolled steel duly powder coated or stainless steel (ss-304) (as ordered). ø  the working table is made of stainless steel sheets (ss-304 grade). ø  window with predefined locking device opens up to 20 cm mm 5 mm height of working. ø  u.v. built-in insecticide light ø  work area sterilization facility before and after use. cock - for gas, air or vacuum, (only 1 no.) is provided. ø  the work area is illuminated by the fluorescent light in the unit. ø  the blower and motor assembly is statistically and dynamically balanced from 1/5 h.p. capacity works with a minimum noise level. ø  the work table provides the working condition of comfortable "sit down" for the operator. ø  single phase 220/230 volt ac. full supply with cord and plugs to work on the supply. applications: ü  clinical laboratory processes ü  biotechnology ü  pharmaceutical industry ü  general health care sectors ü  r&d and industrial sectors ü  bacteria & virus handling   technical specifications: model no: medisef/bs-101 medisef//bs-102 medisef//bs-103 medisef//bs-104 table size 2' x 2' 3' x 2' 4' x 2' 6' x 2' working size 2' x 2' x 2' 3' x 2' x 2' 4' x 2' x 2' 6' x 2' x 2' hepa filter size 2' x 2' x 6" 3' x 2' x 6" 4' x 2' x 6" 3' x 2' x 6" no. of blower 1 1 1 1 illumination 1 x 40 w 1 x 40 w 2 x 40 w 2 x 40 w cabinet materiel wood or cold rolled steel powder coated or stainless steel (ss-304) work table stainless steel (ss-304 grade) view window in work chamber to monitor the samples main filter hepa filter (99.97% efficient at 0.3 micron particles) pre-filter high efficiency pre-filter (washable) sterilization by u. v. germicidal tube in work area. manometer static pressure analogue type. sliding sash counter balanced door for effortless operation. noise level less than 65 db. standard accessory gas/air cock and multipoint 15/5 amp. electric socket. electric supply ac 230v, 50/60hz optional features of biosafety cabinet static pressure manometer can be provided at an additional cost per running fee will be increased exhaust ducting cost per running fee will be increased hepa filtration at exhaust can be done at an additional cost virus burn out at exhaust can be done at an additional cost interlocking of u.v.   germicidal tube & fluorescent light auto switch off / on mode for motor blower when door is closed / open hour meter totalizer for u.v. light can be done at an additional cost glove ports and gauntlets can be done on an extra cost fumigation tray – for effective disinfection/ decontamination can be done at an additional cost electronic filter choke alarm (differential pressure monitor).

Bed Side Locker/Trolley Frame work of CRCA / mild steel tubes Mounted on 75mm noiseless swiveling casters, two with brakes   Two stainless steel shelves with railing on three sides One M.S. drawer below the top shelf Provision for I.V. rod Pre-treated and epoxy powder coated Overall ApproxSize: 60L x 45W x 80H cm

Medisafe Vertical Autoclaves are most ideal for critical applications requiring assured and reliable total destruction of all living micro-organisms. An Ideal tool for Laboratories, hospitals, nursing homes, R & D labs etc. CONSTRUCTIONAL AND SALIENT FEATURES Inner made of Stainless Steel and outer made of(mild steel) Electro galvanized steel Duly Powder Coated Sheet enamel painted. Heaters cover stand and bucket are made of Stainless Steel Sheet. Lid is made of Electro galvanized steel Duly Powder Coated plate lined with stainless steel from inside. Supporting Ring & Legs are made of Electro galvanized steel Duly Powder Coated duly enamel painted. Lid is fitted with Pressure Gauge, Spring Loaded Safety Valve, Manual Exhaust Valve and water level indicator. Drain Valve facilitates easy cleaning of the chamber. Gasket is made of neoprene. All internal joints are argon arc welded. Piezostat (Pressure Control Switch & Low water Level Cut Off system for general safety of the element are available at an extra cost. (OPTION) Operating range from 15psi to 20 psi pressure. To work on 220/230Volts, 50/60 Hz AC supply.                                   Options Digital ON/OFF timer with LED display. Digital Temperature Indicator with RTD. Semi-Automatic Digital Controller with AUTO-TIME CONTROL SYSTEM. After the set temperature is attained the timer starts automatically and on completion of set count down/up time the supply to heaters is cut-off and the system sounds a buzzer alerting user that the cycle is over. Digital Pressure Indicator displayed directly into the main control panel