Earthing Equipment Dealers in Udyog Vihar, Gurugram

Portable Earthing Equipment are safety equipment designed for discharging & grounding of dead equipment. The system is designed for high fault levels so that even if during shut downs, when technicians are on the job, by mistake if the supply is switched ON, the Portable Earthing Equipment saves human life as well as equipment under maintenance. Special Line End & Earth End Clamps along with operating socket and earthing lead are used. The Line End Clamps, Earth End Clamps & operating sockets are made of very special aluminum alloys which can withstand high short circuit currents.

• Application: In High Voltage Applications
• Type: Non Linear Carbon Type
• Features: Highly Durable, Optimum Strength
• Cable Type: Flexible Copper Cable
• Use: Industrial
• Finishing: Polished

Non linear carbon discharge resistor type discharge rods are used to discharge dead system having limited fault levels and also to discharge the static & induced charges in the dead system or equipment, particularly in transmission lines, cables, transformers, reactors, large bus bar systems, switch-gears etc. the earthing lead is made up of special highly flexible braided copper cable with transparent sheath. copper hook of 4” dia of ½” thick copper rod & earth end clamp of special alloy are provided. Maininsulation : 'f' classto is, bs & iecs pecifications For dimensions of insulated rods please refer specifications of insulated sticks in the beginning of electrical safety.   Features Discharge head fitted in the discharge rod Extension handles to extend the length 4" dia copper hook for bus bars Special waterproof carrying cases Theory for controlled discharging When discharging inductive apparatus (transformers, reactors etc.) controlled discharging must be used. we provide non linear carbon discharge resistor for this purpose which prevents the lightning impulses appearing across the equipment being discharged. while discharging inductive loads the emf induced across the object is directly proportional to rate of change of flux i.e.   Since l (inductance) is usually large and the discharging takes place in microseconds, a huge impulse voltage resembling a 1.2/50 μsec pulse appears across the object (a typical waveform is shown in fig), thus subjecting the equipment under discharging to a lightning impulse voltage.   To overcome this non linear carbon discharge resistor is employed. the reverse temperature coefficient of carbon facilitates controlled discharging. as the current flows through the carbon resistance, this increases the temperature and by virtue of reverse temperature coefficient, the resistance falls. therefore as the current is flowing, voltage is reducing and since resistance is also reducing acontrolled discharging takes place.   The do fuse operating rods has and innovative design for fitting, removing & changing drop out fuses. the do fuse. operating rods has a spring loaded fuse jaw which accepts the do fuses easily and ensures that it does not fall while fitting or removing. the entire operation is carried out from ground level comfortably.   This method saves considerable amount of time and effort for fuse replacement and provides extremely safe procedure as compared to the conventional procedures.