Indorub Industries Basai Road, Gurugram, Haryana

These are some of the most common hoses used in hydraulic systems on mobile and stationary equipments. The hoses conforms to the SAE standard J 517 and designated with 100R series. Indorub manufactures all important commonly applicable grades of hydraulic hoses like SAE 100 R1,,R2, R3, R6 etc.. These hoses are wire braided (double) where very high hydraulic pressure applications are involved and single wire braided where subjected to moderate pressures.

Hydraulic hoses corresponding to SAE 100 R16 series. The hose meets or exceeds the requirements of SAE 100 R16 and DIN EN 857. These hoses are mainly recommended for medium & high pressure hydraulic lines (single & double wire braided, respectively) with petroleum and water-glycol base fluids and having bend radius nearly half to that of SAE 100 R1 & R2 Hoses, respectively.

These are single or double textile braided rubber hoses recommended for air conditioning applications.the hoses are designed for application using refrigerant 134a only. The hose meets or exceeds the requirements of sae j 2064, type a.

We are offering cng hose. The a.c. Hose is wire braided and designed for application using refrigerant 134a only. The hose meets or exceeds the requirements of sae j 2064, type b. This a.c. Hose has textile yarn impregnated cover with synthetic elastomeric cement (red colour). The cng hose is designed for use in motor vehicles with cng installations. The hose meets or exceeds the requirements of sae j 30 r6 standard.

It is wire braided rubber hose used for domestic and commercial installations. The hose conforms to the Indian Standard (IS : 9573). This hose has a much longer life as compared to other products used for similar applications.

This hose is specially designed for use in industry to transfer steam at high temperature. The hose is single wire braided with steam and heat resistant inner tube and cover. This hose meets or exceeds requirements of IS 10655, Type 2.

These are textile braided (double) or single wire braided rubber hoses designed for use in petroleum based fuel dispensing. The textile braided hose is specially constructed with electrically bonded copper wire and meets or exceeds requirements of IS 2396. The wire braided hose meets or exceeds the requirements of EN 1360 standard.

We are offering jack & rig hose. Jack hose is wire braided (double) hose designed for use in hydraulic jack application used in jacking system. The hose is specially constructed with synthetic oil resistant tube. Rig hose is wire braided (double) rubber hose, specially designed for hot air applications. The hose is constructed with synthetic oil and high temperature resistant inner tube and a textile braided cover impregnated with synthetic rubber cement.

Hydraulic hose is rarely used without connectors. Hoses with connectors attached are commonly referred to as hose assemblies. The range of hydraulic hose connectors conforms to SAE (American Standards), BS (British Standards) and DIN (German Standards). Hose assemblies may be fabricated by the manufactureres, customer or by the user.

Low pressure, textile braided rubber hoses mainly used for general industrial applications like wate delivery, suction, steam, cement grouting, breweries, petrol pump, oil suction and discharge and chemicals etc. Indorub manufacture a wide range of industrial hoses and each type of hose is having different type of construction. For eg… a carbon free hose is a non - conductive (electrical) hose used as an outer protective covering for power cable in steel mills, glass works etc.

It is wire braided rubber hose used for domestic and commercial installations. The hose conforms to the Indian Standard (IS : 9573 TYPE IV). The hose is designed for a maximum working pressure of 2.5 Mpa. The hose has great safety advantage over other types of tubes used for the same purpose. More so, it is safe from rodent attacks and flame resistant. This hose has a much longer life as compared to other products used for similar applications.