Networking Devices and Equipment Dealers in Jawahar Nagar, Hyderabad

Compliant with EN5015550121-3-2 environmental Management through console, Telnet, SNMP V1, V2c &V3, RMON, Web Browser and TFTP Supports Port-base VLAN, IEEE802.1Q VLAN Tagging and GVRP Supports STPRSTP and EtherWAN α-ring for Ethernet redundancy IP multicast filtering through IGMP Snooping V1, V2 and V3 IEEE802.1p QoS with four priority queues MAC-based trunking with automatic link fail-over Supports IEEE802.3ad Link Aggregation (Port-Trunking) : MAC-based Port-Trunking Supports IEEE802.1x port-security -40XC to +75XCC operating temperature range (Tested @ -40XCC to +85XCC) Ingress & Egress rate control by port. "Broadcast", "Multicast", andor "DLF" (Destination Lookup Failure) from Storm-control enabled type for the port. Port-lock for authorized MAC address access only. Port mirroring Firmware upgrade supported by Telnet, Console port and Web Interface TFTP Front panel port status LEDs Support Din-Rail and Wall Mount installation

We import and supply, the Video Integrated Network Access Controller. The Video Integrated Network Access Controller is a sophisticated device, with excellent video quality. The Network Access Controller can be connected to any server and supports multiple local or remote site door sub-networks.

Manual operation of maintaining the employee log is a mundane task prone to human errors. This project “Employee log system using PC and RFID” is the best solution for this problem. Radio Frequency Identification (RFID) Card Readers provide a low-cost solution to read passive RFID transponder tags up to 2 inches away. The RFID Card Readers can be used in a wide variety of hobbyist and commercial applications, including access control, automatic identification, robotics navigation, inventory tracking, payment systems, and car immobilization. The RFID card reader read the RFID tag in range and outputs unique identification code of the tag at baud rate of 9600. The data from RFID reader can be interfaced to be read by microcontroller or PC. The project is designed in such a way that the controller will be interfaced to the RFID reader through a line driver IC max232 for serial communication. On the other hand, the controller will also be interfaced to the PC serially. Serial communication is often used either to control or to receive data from an embedded microprocessor. Serial communication is a form of I/O in which the bits of a byte being transferred appear one after the other in a timed sequence on a single wire. Each employee will be sanctioned with a unique RFID card. Whenever an RFID card is swiped over the Reader, it gets the card information and sends to the microcontroller serially. So the controller receives the data and transmits it to the PC, as per the code logic. C# application in PC always interact with serial port and it maintain the data base along with corresponding card details. So based on the received data the application can update the employee/student log. As per the design of the application , we can check the employee logs on the required dates at any time. This project uses regulated 5V, 500mA power supply. 7805 three terminal voltage regulator is used for voltage regulation. Bridge type full wave rectifier is used to rectify the ac output of secondary of 230/12V step down transformer.     Micro Controller : AT89S52 Crystal : 11.0592 MHz Lcd : HD44780 Pc Rfid Reader Max232 Software Requirements Keil Proteus Uc Flash C# Embedded C

• GSM Modem: GSM/SMS/GPRS Modem

we are offering wavecom fastrack gsm/gprs modem.dual-band gsm external modem egsm9001800mhz or egsm9001900mhz small size and aluminum shell shock install and us, connect internet instantly has been through all the technical standards certification voice, messaging, fax and data transmission of gsm phase2 + designed for a specific application of the at command control system.

• Type: 10/100 Mbps auto-sensing MDI/MDIX
• Speed: 110 bps to 230.4 Kbps
• Connector: RJ45
• Protection: 1.5 KV isolation
• Data Bits: 5, 6, 7, 8
• Protocols: ICMP, ARP, IP, TCP, UDP, DHCP, Telnet, HTTP, SNMP, SMTP
• Configuration: Web console, serial console, Telnet console, or Windows utility

we are offering gprs modem.data transmission unit(dtu): dtu acts as data transporter. It is provided with rs232, rs 485 communication ports which are used for collecting the data from various equipments and send to a central monitoring center. Data from dtu to server is transmitted through gprs alerts can be communicated to 10 mobile numbers firmware up gradation through dota

• Country of Origin: Made in India
• Application: Industrial
• Type: gsm
• Brand Name: argus

access control, sensor, Metal Detector, Gps Modem, Fire Extinguisher, cctv

digital leased line modems, line drivers, specialized modems

used server, Refurbished Server, Remote Control Shutters, KONE Patient Lift

Ethernet Modem And Mux

GSM Wireless Module, High Power Led, pic microcontroller

network bridge

modem, Computers, Computer Keyboard, Laptop, Memory Cards, Printer

Computer Modems

modem, Computer, Laptop, Printer, Desktop, Keyboards, Mother Boards

network interface cards

modem, Mother Boards, Keyboards, RAM, Hard Disk, monitor, Desktop

modem, Computer, Usb Pen Drive, Mother Boards, Keyboards, RAM, monitor

modem, Laptop, Mother Boards, Keyboards, Hard Disk, monitor, Desktop