Ultrafiltration Systems Dealers in Yellareddyguda, Hyderabad

Basically it is a filtration technology in which physical separation of fine suspended particles, colloidal impurities & micro organisms from the water. With this we can able to remove Turbidity, Silt, Microbial & Colloidal Silica. It contains Hollow Fiber modules which is having 0.01 µ pore size and water can be pushed from either ways (insideout or Outsidein) at low pressures. These are back washable.

Ultra filtration is a method of removing very small particles from liquid. A membrane used with this method usually has pores that are 0.01 to 0.001 microns in size. This is small enough to remove most bacteria, viruses, high molecular weight substances, and polymer-type molecules. During ultra filtration the flow of liquid gets split into two streams, which is known as cross-flow separation. One stream goes through the porous membrane and is then called permeate, and the other is concentrated in the particles and other matter that have been unable to penetrate the membrane.The process is commonly used for treating drinking water in compliance with strict standards. Many organisms have become resistant to other methods of disinfecting water, but an ultra filtration system removes pathogens by moving water through a membrane, physically removing each organism. The membranes themselves are often formed into small, hollow fibers that are less than a millimeter (about 0.04 inches) in diameter, which are bundled by the thousands in a filter housing. Modules that contain the membranes come in a variety of configurations, including spiral-wound, plate-and-frame, and tubular. The type and concentration of material that needs to be removed helps determine what kind of configuration is used.     Ultra filteration is low pressure crossflow membrane process for separating selective molecular weight species from a feed system. The separation is based on selective MWCO (Molecular weight cut-off) Water, Salts and Low molecular weight species selectively pass through the membrane for discharge, reuse or further treatment.   Ultrafilteration selectively removes Macromolecules Suspended Solids Turbidity Organics Bacteria Oil and Grease Surfactants Pigments Metal Hydroxides

Ultrafiltration system , Aqua flow systems offers turnkey solution to all your water & waste water treatment needs right from the process design, detailed engineering, manufacturing, erection, commissioning and post commissioning services. We are involved in supplying state-of-the-art technology for packaged drinking water system, effluent treatment plants, sewage treatment plants, lechate treatment plants, stripper, MEE, and ATFD plants. Our services include modification of existing plants, servicing of treatment systems.Temporary Hardness: Temporary hardness of water is due to the presence of bicarbonates of calcium and magnesium. Ca(HCO3)2 and Mg(HCO3)2. Permanent hardness: Permanent hardness of water is due to the presence of chlorides and sulphates of calcium and magnesium (CaCl2, CaSO4, MgCl2,MgSO4.

               The UF system utilizes state-of-the-art, pure polysulfone hollow fibers are asymmetric with the feed stream entering the inside, or lumen of the 35 millimeter (mm) inside diameter fiber. Under pressure of about 15 pounds per square inch (psi), the permeate passes through the membrane at approximately 100 gallons per square foot per day (gfd) flux rate. A backwash is typically engaged via a programmable logic controller (PLC) device on a regular schedule-perhaps hourly. This keeps the UF membrane surface clean even when turbidities spike to over 100 NTUs. The polysulfone fiber is chlorine tolerant and can thus be easily disinfected using chlorine. The UF cartridges are housed in a clear vessel allowing for fiber integrity testing using a visual method or an automatic pressure decay test included in the logic of the PLC.