Lubricating Oil Dealers in Vijay Nagar, Indore

Though recycled sludge oil is a general term applied to any oil, used for the generation of power or heat. Fuel oil can include distillates and blends of distillates and residues, such as light diesel oil. specification recycled sludge oil in the current marketing range meets bureau of indian standards specification is : 1593 - 1982 for fuel oils, grade mv2. viscosity viscosity is the most important characteristic in the furnace oil specification. It influences the degree of pre-heat required for handling, storage and satisfactory atomization. If the oil is too viscous, it may become difficult to pump, burner may be hard to light and operation may be erratic. Poor atomization may result in the carbon deposits on the burner tips or on the walls. The upper viscosity limit for furnace oil is such that it can be handled without heating in the storage tank is excepting under server cold conditions. Pre-heating is necessary for proper atomization. flash point as per the controller of explosives classification, furnace oil falls in the class "c" category with minimum flash point standard of 66°c. Since penskey martens closed cup method is used, it is apparent that a small quantity of low boiling point hydrocarbons is sufficient to lower the flash point drastically. pour point it is a very rough indication of the lowest temperature at which furnace oil is readily pumpable. In the specification the pour point of furnace oil is not stipulated. However, for furnace oil manufactured indigenously and for imported parcels, the pour point is such that current supplies normally can be handled without heating the fuel oil handling installation. water water may be present in free or emulsified form and can on combustion cause damage to the inside furnace surfaces especially if it contains dissolved salts. It can also cause sputtering of the flame at the burner tip. Water content of furnace oil when supplied is normally very low as the product at refinery site is handled hot and maximum limit of 1% is specified in the standard. sediment furnace oil being a blend of residues contains some quantity of sediments. These have adverse effect on the burners and cause blockage of filters etc. However, the typical values are normally much lower than the stipulated value of maximum 0.25 percent, by mass. ash ash is incombustible component of the furnace oil and is expressed as a percentage mass of the furnace oil sample. Ash consists of extraneous solids, residues of organometallic compounds in solution and salts dissolved in water present in the fuel. These salts may be compounds of sodium, vanadium, calcium magnesium, silicon, iron etc. Ash has erosive effect on the burner tips, causes damage to the refractories at high temperatures and gives rise to high temperature corrosion and fouling of equipments.

Lubricants Oil, Mob Oil, Engine Oils, Diesel Oil, lpg gas hose

Lubricants Oil, Auto Clutch Plate, auto gears, Engine oil, Spindle