Water Pumps Dealers in Jalori Gate, Jodhpur

• Application: Water Dispenser
• Automatic Grade: Manual
• Brand Name: Aqua Pure
• Material: Plastic
• Features: Durable, fine Finished
• Pack Type: Box

• Type: DC Water Pump
• Brand Name: SHAKTI
• Power Source: Solar
• Motor Phase: Single Phase
• Type Of End Use: Agricultural
• Voltage: 280V
• Frequency: 50Hz
• Material: Cast Iron
• Pressure: 5 Bar
• Water Discharge Capacity: 300 Litre/min
• Engine: 7.5 HP
• Automation Grade: Semi-Automatic

• Type: Arc Spray Equipment
• Color: Brown
• Voltage: 380V
• Driven Type: Electric, Hydraulic
• Warranty: 1year
• Automatic Type: Manual

electric arc spraying is a thermal spraying process that uses an electric arc between two consumable electrodes of the surfacing materials as the heat source. A compressed gas atomizes and propels the molten material to the workpiece. The principle of this process is shown by figure. The two consumable electrode wires are fed by a wire feeder to bring them together at an angle of approximately 30 degrees and to maintain an arc between them. A compressed air jet is located behind and directly in line with the intersecting wires. The wires melt in the arc and the jet of air atomizes the melted metal and propels the fine molten particles to the workpiece. The power source for producing the arc is a direct-current constant-voltage welding machine. The wire feeder is similar to that used for gas metal arc welding except that it feeds two wires. The gun can be hand held or mounted in a holding and movement mechanism. The part or the gun is moved with respect to the other to provide a coating surface on the part. the high temperature of the arc melts the electrode wire faster and deposits particles having higher heat content and greater fluidity than the flame spraying process. The deposition rates are from 3 to 5 times greater and the bond strength is greater 5000-7000 psi. There is coalescence in addition to the mechanical bond. The deposit is denser and coating strength is greater than when using flame spraying. dry compressed air is used for atomizing and propelling the molten metal. A pressure of 80 psi and from 30 to 80 cu ft/min (0.85 to 2.27 cu m/min) is used. Almost any metal that can be drawn into a wire can be sprayed. Following are metals that are arc sprayed: aluminum, babbitt, brass, bronze, copper, molybdenum, monel, nickel, stainless steel, carbon steel, tin, and zinc.

We are offering brass impeller.

Pump Shaft

Hospital operating solutions, animal healthcare products

Solar Water Pump, electric chimney, Solar Led Light, Solar Panel

Pump Set, Brass Bathroom Fitting, cast iron, galvanised iron fittings