Industrial Dryers Dealers in Panki, Kanpur

A tray or Compartment Dryer is an enclosed insulated chamber in which trays are placed on top of each other in trolleys. The material to be dried either wet or solids are placed in the tray. Heat transfer is done by circulation of hot air by electric heaters in radiator coils. Blower fans are installed inside to ensure proper circulation and transfer of heat. A control panel to control the temperature and other parameters is fixed outside the dryer. There is also arrangement of digital temperature controller.   These dryers available in mild Steel, Stainless Steel or Al construction. Used for drying Pigments food Bakery Electrodes Chemical Plastic Powders

• L&M 12: 80 X 40 X 80 cm
• 135 X 50 X 95 cm: 2
• 1: ½ HP/3PH/440V
• L&M 24: 84 X 86 X 87 cm
• 180 X 95 X 110 cm: 2
• 1: ¼ HP/3PH/440V
• L&M 48: 170 X 92 X 183 cm
• 290 X 102 X 221 cm: 1
• 1: 1 HP/3PH/440V

It is used to dry the Khaini leaves and remove the undesired moisture from it. For customer’s convenience, Rotary dryer comes in different sizes and is equipped with a dust collector to ensure less wastage. Working Principle : The dryer is made up of a large, rotating cylindrical tube, usually supported by concrete columns or steel beams. The dryer slopes slightly so that the discharge end is lower than the material feed end in order to convey the material through the dryer under gravity. Material to be dried enters the dryer, and as the dryer rotates, the material is lifted up by a series of internal fins lining the inner wall of the dryer. When the material gets high enough to roll back off the fins, it falls back down to the bottom of the dryer, passing through the hot gas stream as it falls. This gas stream can either be moving toward the discharge end from the feed end (known as co-current flow), or toward the feed end from the discharge end (known as counter-current flow). The gas stream can be made up of a mixture of air and combustion gases from a burner, in which case the dryer is called a direct heated dryer. The gas stream may consist of air or another (sometimes inert) gas that is preheated. When the gas stream is preheated by some means where burner combustion gases do not enter the dryer, the dryer known as an indirect-heated type. Application : Rotary Dryers have many applications but are most commonly seen in the mineral industry for drying sands, limestone, stones and soil, ores, fertilizers, wood chips, coal, iron sulphate, filter cakes, sewage sludge, etc. It is also applied on food industry mainly for liquids as well as for granular material such as food grains, cereals, pulses, coffee beans, fermented tea leaves, etc.

Industrial Dryer, Rubber Conveyor Belt, pouch cutting machine

Rotary Dryer, Steam Tube Dryer, Agitated Rotor Type Dryer, Tube Bundle Dryer