Power Factor Correction Panel Dealers in Kolkata

We are a prominent Manufacturer & Supplier of Automatic Power Factor Correction Panel. The Automatic Power Factor Correction Panel offered by us is available in the capacity of 60 to 1000 kVAr. Because of the high quality, efficient performance and long working life, our Automatic Power Factor Correction Panel is widely demanded by reputed firms like L&T Ltd., project NISER, Bhubaneswar, Orrisa, Technomac project Durgapur, etc. Specifications : APFC Panel with Microprocessor based relay for controlling power factor within required valuesRTPFC Panels using Thyristor based capacitor switching.Fully ventilation type panelEasy Maintenance and easy to remove capacitorUse of capacitive duty contactorsAlways maintain 0.99PF High-speed power factor correction Provision of detuned reactors the panels for reliable operation in presence of harmonics Features : We followed the proper IP - 54 standardProper water proof facilityAs per NFPA 70E rule - switches are properly covered to protect from deep burn in accident (Arc – flash Hazard)We use FRF supported terminals for – Easy cable connection, Prevent switch from damage and Prevent from short circuitWe use 8.8 HT bolt (Make Unbreako) for Busbar connection , to prevent Heat generation and damage of switchesWe use EC grade Aluminum Bus bar, for better conductivity and less resistance

Ø  What is power Factor? Power Factor (PF) is the ratio of Power Utilized (KW) and Power Drawn (KVA). Generally, when the applied to the electrical motors, the entire power is not converted as useful Work Done (KW). Depending on inductance of the motor a reactive power (KVAR) is generated which results in drawing of excess KVA. PF = KWH / KVAH To reduce the KVA drawn, the inductive KVAR is to be nullified by introducing an equal and opposite Capacitive KVAR according to the load pattern, thus OPTIMUM PF is maintained. Ø  Why Power Factor must be maintained?   By maintaining an optimum PF the Power drawn (KVA) can be reduced, thus reducing the current passing through the electrical circuits to the maximum extent possible (event up to 50%) thereby reducing the machine down time. reduction in heat losses in turn increases the life of the electrical circuits. The State Electricity Boards (SEB’s) has installed Digital Electronic Energy (Tri-Vector) Meters for consumers, which has the provision of showing the PF and insisting to maintain the average Power Factor above a Specified limit (0.85 – 0.90 PF) Otherwise, for every reduction of 0.01 from the specified PF, PENALTY is levied on the Energy Consumption Charges (KWh) on the Electricity Bill. SEB’s are also offering PF incentives if the PF is maintained above the specified PF. In few states, where the metering unit is KVAh and if the PF is maintained at its optimum of 0.99, the electricity bill amount itself is reduced considerably. The optimum Power Factor can be maintained by installing Galaxy Electro Tech’s AUTOMATIC POWER FACTOR CONTROL PANEL Ø  Salient Features of Galaxy Electro Tech’s APFC Panel: Adjustment to any step of capacitor value Micro controller based technology. Digital computation of various parameters Continuous monitoring of parameters like Line Voltage, Current, Active, reactive and Apparent Powers and energies Scrolling Display on a Dot Matrix LCD Protection of Capacitors against damage due to High Voltage, Low Voltage Tends to maintain 0.99 lag Plug-in terminal connection No-Volt release features to disconnect all capacitors in the event of power failure Dynamic control of Reactive Power and Power Factor RS 232 / RS 485 Standard output port (optional) Fine & Coarse correction Controller Ø  Benefits of Galaxy Electro Tech’s APFC Panel: Power Factor penalty is avoided Avail incentives by maintaining optimum Power Factor Optimize the capacity by reducing the maximum demand KVA Avoids excess demand charges Improvement in line voltage Reduced line current losses and cable overheat Enhanced life of electrical circuits Avail Depreciation Reduced consumption (KWH) charges Avoids overloading of Distribution Transformers Additional Service connections in existing generation of power by reducing Energy Losses Reduced line losses Benefits SEB’s and Nation Galaxy Electro Tech’s APFC Panels are available from 25KVAR – 2500KVAR  Model onwards