Pressure Gauges Dealers in Mahanagar, Lucknow

• Packaging Type: Box
• Range: ± 1500 micro strain
• Sensitivity: 1 microstrain
• Material (outer body): Stainless steel
• Coil Resistance: 140 – 160 Ohm @ 25°C

Innovative series IG1100/1200 strain gauges have a unique integral magnet design which incorporates a miniature magnet coil assembly positioned inside a stainless steel tube of diameter 15mm. The same tube has a high tensile strength, heat-treated and tempered steel wire stretched between two end blocks. The wire is sealed in the tube by means of a set of double O-rings. This feature, when compared to conventional externally mounted magnet design has the following advantages: Robust anstallation and minimum protection needed after installation.   Externally mounted magnet assembly on the other hand is prone to corrosion as it is made in two halves, which are externally clamped on to the tube. This does not ensure proper sealing at the joint. Thus water can seep and with time cause corrosion on the magnet, resulting in failure.   Embedment type strain gauges are provided with built in stainless steel flanges while the groutable and arc weldable type have the same design. By the use of appropriate type of mounting blocks, the same strain gauge can be arc welded on to the steel structures such as tunnel linings and supports or grouted or epoxy bonded on the surface of concrete structures.   To take care of space limitation, for vertical measurement of strain across thin concrete lining, embedment strain gauges with 55mm gauge length are used. For eg. on pavements.Provision of gas discharge tube protects the sensor against surge and lightning.   Accessories: 5 position rosette for mounting strain gauge at different angles and in different planes. No-stress container to evaluate strain produced due to factors other than load. Brackets for arc welding on structures or grouting. 6 position junction box to terminate strain gauges installed on Rosette.

• Gauge Length: 55 mm, 125 mm
• Coil Resistance: 130 – 150 Ohm @ 25°C
• Cable: 1m , 4 core shielded.

Strain gauge, straingauges are used to moniter strains in soil, concrete or on steel structures. straingauges can mesure both compresive and tensile strains. Monitoring strains in dams and embankments during and after construction Mesurement of in steels structres supporting tunnels and underground cavities. In pile testing. In pressure shafts and wye sections. In road sections. In high rise buildings.

Temperature Gauges, Analytical Weight Box, Weight Box